Polycom 14117800 manual Configuring the Secondary Kirk Wireless Server

Configuring KIRK Wireless Server 600v3 137

•In the Host Name field, type the host name of the KWS600v3.

The host name consist of ip1200- followed by the last three octets of the MAC address of the KWS600v3 (to be found on the label on the rear of the KWS600v3). Eg. ip1200-0f-01-9d

Note: When clicking the Get button, the system provides the host name automatically. The Get button can only be used, if working online and if the IP address is the specific IP address of the KWS600v3 in question and valid on the whole network.

2In the LDAP area:

•In the Primary field, type the IP address of the primary LDAP Server.

•In the Alt field, type the IP address of the alternative LDAP Server.

3In the Radio area:

•In the Master field, type the IP address of the Master KWS600v3.

•In the Alt Master field, type the IP address of the alternative (Standby) Master KWS600v3.

Note: The radio ID of the KWS600v3 is by default identical to the last octet of its IP address. It is recommended not to change the radio ID.

4Save the configuration now or wait until you have finished configuring the whole installation.

For more information about saving the configuration, refer to “Saving Configurations” on page 141.

7.8.6 Configuring the Secondary KIRK Wireless Server 600v3

This section describes how to configure KWS600v3 secondaries in a multi-cell solution.

After configuring the Master (Primary) KWS600v3, you need to configure each Secondary KWS600v3 to be used in the system.

KIRK Wireless Server 600v3 Installation and Configuration Guide