46Installing the KIRK Wireless Server 600v3

Table 3 Reset Button Description

Press button

Action

 

 

Short press

Restarts the KWS600v3.

 

 

Press until LED flashes fast

Restarts the KWS600v3 in TFTP mode (Trivial File Transfer

 

Protocol). In TFTP mode the KWS600v3 can be reached only

 

through the GWLOAD program. For more information about

 

using the GWLOAD program, refer to “Using the GWLOAD

 

Program” on page 202.

 

 

Press for a longer period

Performs a system reset and configuration preset.

 

The Alarm Indicator and Ready Indicator indicate that you are

 

about to perform a system reset including a configuration

 

preset within a couple of seconds if the reset button is not

 

released.

 

All system settings will be erased and the system returns to its

 

default settings. The actual software will not be affected.

 

Note: After a system reset you must perform at

 

short press on the Reset button again, to prevent

 

the system to start up in DHCP client mode.

 

 

Note: When resetting the Master KWS600v3/LDAP Server, you cannot set up calls until handsets are registered on the call handler again.

4.3 Installing the KIRK Wireless Server 600v3

The KWS600v3 is suitable for mounting indoors on a wall.

A KWS600v3 covers a circular area between 50 and 300 meters/164 and 984 feet, depending on the environment.

Note: Before beginning the installation, it is important to determine the location of the KWS600v3 for the best coverage. The radio coverage depends on the construction of the building, architecture and choice of building materials. Refer to Environmental Requirements on page 26 for more information about environmental requirements for KWS600v3.

Note: Avoid installing KWS600v3 on large concrete or marble columns because these columns affect radio coverage. If possible, place the KWS600v3 a minimum of 1.0 meter/

3.3feet from these types of columns. Do not install a KWS600v3 with the antenna housings near metal objects. Be careful not to damage existing wiring or panels.

Note: Do not position KWS600v3 in ducts, plenums, or hollow spaces used to transport environmental air except where the duct, plenum or hollow space is created by a suspended ceiling having lay-in panels.

14117800, Ed.2.6

Page 46
Image 46
Polycom 14117800 manual Installing the Kirk Wireless Server, Press button Action