88Configuring KIRK Wireless Server 600v3

Call handler specific, refer to KWS600v3 Configuration Guide for the relevant call handler.

9No Display of Date and Time: Enable only if time should not be displayed.

10From the Coder Preferences, select a voice compression value that matches your telephony infrastructure.

Contact your system administrator for more information.

11In the Framesize fields, type the desired frame length in milliseconds and then select either Exclusive or Silence Compression.

Contact your system administrator for more information.

Note: If the Exclusive check box is selected for the coder, then the KWS600v3 is forced to use the coder.

12Click OK.

13Click Reset (under Administration menu) to save your configuration.

7.5.5 Configuring DECT Master

On the Master page you can establish a communication protocol between the KWS600v3 and a call handler.

1Under the Configuration menu, click DECT, and then click Master.

Figure 23 Adm. Page: Configuration/DECT/Master page

2From the Mode list, select Active.

3From the Protocol list, select either H323, SIP or SKINNY depending on the protocol you are using.

4In the GK (Gate Keeper) field, type the IP address of your call handler. Contact your system administrator for more information.

14117800, Ed.2.6

Page 87 Page 89
Page 88
Image 88
Polycom 14117800 manual Configuring Dect Master, Adm. Page Configuration/DECT/Master
Page 87 Page 89
Top Page Image Contents