Polycom 14117800 manual Intrinsic safety

Regulatory Notices 211

6The product should be operated only from the type of power source indicated on the instructions. If you are not sure of the type of power supply, consult your dealer or local power company.

7Do not overload wall outlets and extension cords as this can result in fire or electrical shock.

8Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage points or short out parts that could result in fire, electrical shock, or injury. Never spill liquid of any kind into this product.

9To reduce the risk of electrical shock or burns, do not disassemble this product. Open- ing or removing covers may expose you to dangerous voltages, dangerous electrical current, or other risks. Incorrect reassemble can cause electrical shock when the appli- ance is subsequently used. If the product need repair, consult your dealer.

10This product does not support connections to outside plant.

11Refer servicing to qualified service personnel under the following conditions:

AQ If liquid has been spilled into the product

BQ If the product has been exposed to rain or water

CQ If the product does not operate normally when following the operating instructions in the manual. Adjust only those controls that are covered by the operation instruc- tions. Improper adjustment of other controls may result in damage and will often require extensive work by qualified service personnel to restore the product to nor- mal operation.

DQ If the product has been dropped or cabinet has been damaged EQ If the product exhibits a distinct change in performance

2Avoid using telephone during an electrical storm. There may be a risk of electrical shock from lightning

3Do not use the telephone to report a gas leak in the vicinity of the leak

4Do not place the unit near microwave ovens, radio equipment, or non-ground con- nected televisions. These appliances may cause electrical interference to the base or handset

5The unit must be installed on a hard, plane surface and connected to a functional 120 volt AC power netadapter and plug the adapter into the power outlet

6The system will not operate in the event of a blackout. Please keep a backup phone for emergencies

Intrinsic safety

Do not install the unit in conditions where there is a danger of electrically ignited explo- sions.

Exposure to sunlight, heat and moisture

Do not expose the unit to direct sunlight for long periods. Keep away from excessive heat and moisture.

KIRK Wireless Server 600v3 Installation and Configuration Guide