98 Configuring KIRK Wireless Server 600v3
14117800, Ed.2.6
1Under the Configuration menu, click DECT, and then click Master.
Figure 34 Adm. Page: Configuration/DECT/Master page
2From the Mode list, select Active. Selecting Active defines the KWS600v3 as a
Primary (Master).
3From the Protocol list, select either H323, SIP or SKINNY depending on the protocol
you are using.
4In the GK (Gate Keeper) field, type the IP address of your call handler.
Contact your system administrator for more information.
5In the Alt-GK (Alternative Gate Keeper) field, type an alternative IP address of your
call handler (optional).
Contact your system administrator for more information.
6GK-Id field:
Call handler specific, refer to KWS600v3 Configuration Guide for the relevant call
handler.
7Click OK.
8Click Reset (under Administration menu) to save your configuration.
7.6.1.8 Configuring DECT Radio (Primary)
On the Radio page you define which radio ID the Master KWS600v3 and Sync Source has
to synchronize with.
Note: In a multi-cell installation with max. 10 KIRK Wireless Server primary and
secondaries and/or 100 handsets, the Master KWS600v3 can be used as radio unit. If
using the radio part on a Master KWS600v3, configure it as described in “Configuring
DECT Radio (Secondary)” on page 116.