100Configuring KIRK Wireless Server 600v3

•If CISCO network: It is recommended to change the TOS priority - RTP Data to 0xb8.

3In the TOS priority - Signalling field, type a TOS priority.

Depending on the network, it may be necessary to change the TOS priority.

•Most networks: The default TOS priority is: 0x10

•If CISCO network: It is recommended to change the TOS priority - RTP Data to 0x68.

For information about the TOS priorities used in your network, contact you system administrator.

4Click Reset (under Administration menu) to save your configuration. The Master (Primary) KWS600v3 is now configured.

7.6.2 Configuring Sync Master

This section describes how to configure a Sync Master KWS600v3 in a multi-cell solution.

KWS600v3 primary and secondaries use the existing DECT air interface to synchronize to each other on. One KWS600v3 is configured as a Sync (synchronization) Master in the system. It is not necessary to configure what KWS600v3 the Sync Master should synchronize to.

This section includes information about:

•“Assigning a Specific IP Address (Sync Master)” on page 100

•“Configuring LDAP Replicator (Sync Master)” on page 102

•“Configuring DECT Master (Sync Master)” on page 103

•“Configuring DECT Radio (Sync Master)” on page 103

For information on accessing the web based Administration Page, refer to “Accessing the Web Based Administration Page” on page 79.

7.6.2.1 Assigning a Specific IP Address (Sync Master)

To assign a specific IP address to the KWS600v3, it is necessary to disable the DCHP mode and then assign a specific IP address to the KWS600v3. The new IP address and network address will be provided by the system administrator.

14117800, Ed.2.6

Page 99 Page 101
Page 100
Image 100
Polycom 14117800 manual Configuring Sync Master, Assigning a Specific IP Address Sync Master
Page 99 Page 101
Top Page Image Contents