136Configuring KIRK Wireless Server 600v3

For more information about saving the configuration, refer to “Saving Configurations” on page 141.

7.8.5 Configuring Sync Master

This section describes how to configure a Sync Master KWS600v3 in a multi-cell solution.

KWS600v3 primary and secondaries uses the existing DECT air interface to synchronize to each other. One KWS600v3 is configured as a Sync (synchronization) Master in the system. It is not necessary to configure what KWS600v3 the Sync Master should synchronize to.

In the Sync Master tab you configure the Sync Master.

Figure 75 Configuration Tool: Sync Master tab

1In the IP Address area:

Deselect the DHCP check box.

First time you power up the KWS600v3 it acts as a DHCP client. To assign a specific IP address to the unit, it is necessary to disable the DHCP mode.

In the IP Address field, type the IP address of the Sync Master, provided by your system administrator.

This IP address is now the default address when accessing the Sync Master.

In the Network Mask field, type the network mask.

In the Default Gateway field, type the IP address of the gateway.

14117800, Ed.2.6

Page 136
Image 136
Polycom 14117800 manual Configuration Tool Sync Master tab