Updating Radio File | Polycom 14117800 guide

System Management 179

1Under the Administration menu, click Upload, and then click Firmware.

Figure 114 Adm. Page: Administration/Upload/Firmware page

2Click Browse.

A dialog box appears.

3Select the firmware in question, and then click Open.

4Click Upload.

Wait until the system has finished updoading.

Note: Do not interrupt firmware upload. If this process is interrupted, the firmware in the KWS600v3 will be defect.

Note: If the firmware upload is interrupted, the firmware must be uploaded again before rebooting the system.

5Click either Reset Immediately or Idle Reset.

When resetting the KWS600v3 immediately, all calls are terminated and the KWS600v3 is reset. When resetting the KWS600v3 when the system is idle, the reset is done when there are no active calls in the KWS600v3.

10.1.9.3 Updating Radio File

The radio file of the KWS600v3 can be updated. To update the radio file you load a file to the system. Contact your distributor for newest software.

KIRK Wireless Server 600v3 Installation and Configuration Guide

Image 179

Polycom 14117800 manual Updating Radio File, Adm. Page Administration/Upload/Firmware

Contents

Part No , Ed.2.6 April 16 Proprietary and Confidential Contents Installing the Kirk Repeater Kirk Handset Registration and Subscription 145 Chapter Configuration/General/Update 189 Configuration of an NTP Server / Client 197 14117800, Ed.2.6 Figures Adm. Page Configuration/ETH0/IP Configuration Tool Alt Master tab Adm. Page Administration/Download/Config Contents Tables 14117800, Ed.2.6 Preface Before You Begin Chapter Overview Where is it? What is it about? When to use it? Related Documentation Ipei Acronyms Preface 14117800, Ed.2.6 This section provides information about Introduction Kirk Wireless Server Components of the Kirk Wireless Server 600v3 Solution Kirk Repeater Wireless Bands Kirk Handset Kirk SIO Application Interface Auto Login and HandoverKirk Maintenance Software Kirk Wireless Server Environmental Requirements Requirements for the Kirk Wireless Server 600v3 Solution Introduction Kirk Repeater Environmental Requirements Electrical Requirements Kirk Handsets Environmental Requirements Software Requirements Deploying Kirk Wireless Server Sync over Air Recommendations for KWS600v3/KIRK Repeater PlacementDeployment of a Kirk Wireless Server 600v3 Multi-Cell Examples of Synchronization Chains Synchronization Chain With One Sync Master Primary Sync Ways Synchronization Chain With Alternative Sync Ways Synchronization Chain with Alternative Sync Ways Synchronization Chain Layout with Alternative Sync Ways Synchronization Chain With and Without Alternative Sync Ways Synchronization Chain With Repeaters Deploying Kirk Wireless Server 14117800, Ed.2.6 Inspect for Damage Installing the Kirk Wireless ServerDescription of Kirk Wireless Server Unpacking Kirk Wireless Server 600v3 Appearance and Components Kirk Wireless Server 600v3 Types and Part NumbersVariants of Kirk Wireless Server Part Number KWS600v3 faceplate includes the following see figure below LED that indicates whether or not the unit is functioning LED Indicator Meaning Kirk Wireless Server 600v3 LED Indicators Front Cover Faceplate Kirk Wireless Server 600v3 Reset ButtonResetting the Kirk Wireless Server 600v3 Hardware Press button Action Installing the Kirk Wireless Server Connect the wire into the RJ45 plug on the KWS600v3 Kirk Wireless Server 600v3 Indoor Wall Mounting Recording the Installation Information Kirk Repeater provides RF Channels to Kirk Handsets Installing the Kirk RepeaterKirk Repeater Description Kirk Repeater Business 1.8 GHz, 4 channels Kirk Repeater Types and Part Numbers Kirk Repeater Appearance and Components Kirk Repeater LED IndicatorsInstalling the Kirk Repeater Installing the Kirk Repeater 3Repeater and External Antenna Installed on the Wall Content of the Kirk Programming Kit Repeater Checking IndicatorsPowering the Kirk Repeater Power Options Programming the Kirk Repeater with the ServiceTool Set up of the Hardware for Repeater Programming Base Station Repeater Installing the Kirk Repeater Installing the Kirk Repeater Installing the Kirk Repeater Installing the Kirk Repeater Installing the Kirk Repeater Installing the Kirk Repeater Numbering of repeaters in a repeater jump configuration Radio Link Use of Kirk Repeater With External AntennaSynchronization Ways Kirk Handset Description Preparing Kirk Handset for Use Variants of Kirk Chargers Kirk Handset TypesVariants of Kirk Handsets Kirk Charger Types and Part Numbers Power Supply Types and Part Numbers Installing BatteryVariants of Power Supplies Installing Battery on Kirk 3040 Handsets Installing Battery on Kirk 4020/KIRK 4040/KIRK 4080 Handsets Remove Back Cover from Handset with Screw Fastener Installing Battery on Kirk 5020 / 5040 Handsets Charging Kirk Handsets Using the Charger Single Charger for 4080 Handset Place the handset in the charger Kirk 5020 / 5040 Handsets Retrieving the Serial Number of the Kirk Handset Retrieving Serial Number on Kirk 3040 Handsets Retrieving Serial Number on Kirk 5020 / 5040 Handsets Preparing Kirk Handset for Use 14117800, Ed.2.6 KWS600v3 supports Power over Ethernet, PoE 802.3af Configuring Kirk Wireless ServerPowering up the Kirk Wireless Server Power over Ethernet Checking Indicators Connecting a Computer to the Kirk Wireless ServerLocal Power Supply How to Change Internet Protocol Properties using Windows XP Accessing the Web Based Administration Local Area Connection Properties dialog box Starting the Kirk Configuration Tool Accessing the Kirk Configuration ToolHow to Access the Administration Installing the Kirk Configuration Tool Configuration Tool startup window Configuring Single-Cell Solution through Administration Wireless Server 600v3 Single-cell installation Entering a System User Name and Password Assigning a Specific IP Address Adm. Page Enter Network Password dialog box Adm. Page Configuration/ETH0/IP Adm. Page Configuration/ETH0/Link Configuring Ethernet Link Local R-Key/Display Handling check box Configuring Dect SystemFrom the Tones list, select a ring tone Enbloc Dialing check box Adm. Page Configuration/DECT/Master Configuring Dect Master GK-Id field Configuring Dect RadioConfiguring TOS Type of Service Priorities 0x68 Configuring Multi-Cell Solution through AdministrationUnder the Configuration menu, click IP 0xb8 Wireless Server 600v3 Multi-cell installation Configuring the IP Master Primary Kirk Wireless Server Assigning a Specific IP Address Primary Entering a System User Name and Password Primary Adm. Page Configuration/ETH0/DHCP Obtaining a Multi-Cell License Primary Click either Reset Immediately or Idle Reset User fields, type the user names Configuring Ethernet Link Primary 0xff up to Configuring Dect System Primary0x7f up to128 Configuring Dect Master Primary Configuring Dect Radio Primary Configuring TOS Type of Service Priorities Primary Assigning a Specific IP Address Sync Master Configuring Sync Master Adm. Page Configuration/ETH0/DHCP Adm. Page Configuration/LDAP/Replicator Configuring Ldap Replicator Sync Master Configuring Dect Radio Sync Master Configuring Dect Master Sync Master Configuring the Alternative Master Kirk Wireless Server Assigning a Specific IP Address Standby Entering a System User Name and Password Standby Adm. Page Configuration/ETH0/DHCP Configuring Dect Master Standby Configuring Ethernet Link Standby Select the Disable check box to disable the radio Click OK Configuring Dect Radio StandbyConfiguring the Secondary Kirk Wireless Server WS600v3 Multi-cell installation primary and secondaries Entering a System User Name and Password Secondary Assigning a Specific IP Address Secondary Configuring Ethernet Link Secondary Setting Ldap Replicators Secondary Configuring Dect Master Secondary Configuring Dect System Secondary Configuring Dect Radio Secondary Configuring Standalone Ldap Server Configuring Secondary KWS600v3 Using a Back-Up File Setting Ldap Mode Ldap Server Select the Disable check box to disable the radio Configuring Dect Master Ldap Server Configuring Alternative Ldap Server Setting Ldap Replicator Alt. Ldap Server Setting Ldap Mode Alt. Ldap Server Adm. Page Configuration/LDAP/Replicator IP Address area Deselect the Dhcp check box Configuration Tool Master tab Configuring Kirk Wireless Server Gatekeeper area From the Mode list, select Active Master tab you configure the Master Primary KWS600v3 Configuring the Master Primary Kirk Wireless Server Configuration Tool Master tab Configuring Kirk Wireless Server Configuring the Alternative Master Kirk Wireless Server Configuration Tool Alt Master tab Configuring Kirk Wireless Server 600v3 Ldap Server tab you configure the Ldap Server Configuring Ldap Server Configuration Tool Ldap Server tab Configuring Alternative Ldap Server Configuration Tool Alt Ldap Server tab Configuration Tool Sync Master tab Configuring the Secondary Kirk Wireless Server WS600v3 Multi-cell installation primary and secondaries IP Address Range area Secondaries tab you configure the Secondary KWS600v3 Configuration Tool Secondary Settings dialog box IP Settings Shared area Select files to upload dialog box appears Saving ConfigurationsUploading Configuration Files Configuration Tool Select files to upload dialog box Configuration Tool Upload dialog box Select configuration text files to open dialog box appears Opening Configuration Files Registering Kirk Handsets Registering Handsets Using Skinny ProtocolKirk Handset Registration and Subscription Click New An Edit User dialog box appears Adm. Page Administration/DECT/Users Registering Handsets Using H.323 Protocol Click New An Edit User dialog box appears Registering Handsets Using SIP Protocol Click New An Edit User dialog box appears Kirk Handset Registration and Subscription Before subscribing handsets you need to ensure Subscribing Kirk HandsetsKirk 3040 Handset Subscribing Handsets Changing to another System Manually Changing to another System Automatically Using Auto Login aPress Menu go to Menu Login Press 3 go to Select Login Subscribing a Handset to Different Systems Kirk 4020/4040/4080 Handset Subscribing Handsets Kirk 5020 / 5040 Handset Changing to another System Automatically Using Auto Login BPress 3 go to Select Login Auto a Press 3 go to Select Login Auto B Creating Login Subscribing Handset Subscribing a Handset to Different Systems Kirk Handset Management Viewing Handset/User Configuration Kirk 3040/4020/4040/4080 Handset To unsubscribe a handset Press Menu Press go to Menu LoginSearching for Handset/User Information Unsubscribing Kirk Handsets Handset has been unsubscribed Removing Kirk Handsets from the List Deregistering Click Delete Changing User Configurations Programming Kit Handset Part no for 3040 Handset consists Adjusting the Kirk HandsetContent of the Kirk Programming Kit Handset Change settings, and then click Apply Click OK Adjusting the Kirk Handset with the ServiceTool Set up of the Hardware for Kirk Handset Adjustment System Management Using the Web Based AdministrationChanging System User Name and Password On the General/Info page you can read information about Reading System Information Statistics Reading Dect Statistics Click Show UsersUnknown IP-master Calls Radios Adm. Page Administration/DECT/Unknown Radio Calls Master Calls This page provides information about the selected server HandoversReading Ldap Server Status Reading Ldap Replicator Statistics This page provides status information on the interface Reading Ethernet Statistics Click Clear if you want to delete all information Diagnostics Tracing Under the Administration menu, click DiagnosticsLogging Adm. Page Administration/Diagnostics/Tracing Config Show Ping Making a Back-Up of the Configuration File Click Download Updating the Kirk Wireless ServerUnder the Administration menu, click Download This section describes how to update the following Updating Firmware Updating Configuration FileUnder the Administration menu, click Upload Updating Radio File Adm. Page Administration/Upload/Firmware Click Browse Updating Boot FileClick Send file There are three ways of resetting the system Resetting the Kirk Wireless ServerResetting Kirk Wireless Server 600v3 Immediately Click OK to reset the system immediately Resetting Kirk Wireless Server 600v3 When System is Idle Kirk Repeater Programming Using the ServiceToolResetting in Tftp Mode Adjusting the Kirk Handset Description of Different Types of MSF Messages Messaging over MSF Activating MSF Messages Function Adm. Page Configuration/General/Telnet Sending Text Messages Messaging over MSF 14117800, Ed.2.6 Example Configuration/General/UpdateName Value Interval Current Update Serials System Requirements Configuration of the Update ServerInstallation Configuration Times Command Running MaintenanceMaintenance Commands Check Command Mod cmd UP1 times /allow 12,22,23,0,1,2,3,4 Prot CommandMod cmd UP0 prot url final-command built-serial Mod cmd UP0 prot http//192.168.0.10/firm/ip1200.bin ireset Bmc command only for Dect devices Boot Command Current date and time Scfg Command#bn Rolling backup index Sequence Replaces Example Example Configuration of an NTP Server / Client Example No Sys-Object TroubleshootingSolving Problems in Kirk Wireless Server Administration Page of the Kirk Wireless Server On all radio units with Problem Action requiredKirk Configuration Tool for Kirk Wireless Server Subscribe even if System ID has been Found Should You Need to Report a ProblemKirk Repeater Problem Action required Not ring Not possible to turn Question General Answer Frequently Asked QuestionsUsing the Gwload Program An Open IP firmware file dialog box appears File Setup area, click IP firmwareKirk WS area, click KWS600v3 Click Get File Gwload Upload dialog box Click Upload Following dialog box appears Sätetele Regulatory NoticesInternational Regulatory and Product Information Relevante krav i direktiv 1999/5/EF Español Spanish EnglishEssential requirements and other relevant Provisions of Directive 1999/5/EC Suomi Finnish KWS600V3 Server tyyppinen laite on Explosive Device Proximity Warning Appropriate RF safety/installation Information Safety Important Safety Instructions and Product Information Intrinsic safety Spare parts and accessories Regulatory Notices Limited Warranty Regulatory Notices Regulatory Notices 14117800, Ed.2.6 Index 14117800, Ed.2.6 Index 14117800, Ed.2.6