3. TOOLS REQUIRED
1.1/2" or Adjustable Wrenches
2.7/16" or Adjustable Wrenches
3.Funnel
4.DISCONNECTING SPARK PLUG
Disconnect the spark plug wire and move it away from the spark plug before assembling the
r_ | /Spark | Plug Wire |
Figure 2
5. A'I-rACHING DISCHARGE CHUTE
Remove the wing knobs from each side of the discharge opening on the
Using two 7/16" wrenches, remove hex lock nut, two spacers, and the hex bolt from top of the housing assembly. For easy assembly, do not remove the second spacer from the hex bolt. Place the discharge chute in position on the discharge opening. Insert hex bolt and spacer through hinge on discharge chute and housing (spacer fits inside of hinge). See figure 3 inset.
Hex Nut
J
Hex Bolt
J
Hinge
Knob
Discharge |
|
Chute | Knob |
Figure 3
Place second spacer over hex bolt inside the other part of the hinge. Secure with hex lock nut. Tighten securely.
Secure both sides of discharge chute to housing using wing knobs that you earlier removed. Tighten wing knobs.
6. A'n'ACHINGHOPPER ASSEMBLY
Remove the
Place the hopper assembly on the ground and hold it in the position shown in step 1 in figure 4. Holding the hopper, push hopper pivot door down inside the hopper. See figure 4.
Slide the hopper assembly towards the chipper- shredder housing so that the upper guide on the hopper assembly slides under the stop washer on each side of the inlet guide. See figure 4. Align the two holes (one on each side) of the lower hopper with the two holes (one on each side) of the inlet guide.
Insert the hex bolt (that you earlier removed) from the left through the hole on the hopper and the inlet guide. Insert the hex nut onto the bolt from the other side. See figure 4 inset.
Inlet Guide Opening
Hopper Pivot Door | Hopper | Hex |
|
| Nut |
\
Stop
Inlet Guide | Hopper |
Figure 4
6
