Craftsman 286.26829 owner manual Professional Twin Cutter SAW, ONE Full Year Warranty on Craftsman

Warrartty		Page	2
Safety	Instructions	Pages	3-8
Safety	Symbols	Page	8
Description		Page	9
Operation		Pages	10-19
Removing and Installing Blades		Pages	17-19
Maintenance		Pages	19-20
Troubleshooting		Page	21
Accessories		Page	21
Repair	Parts	Pages	22-23
Service	Numbers	Back Cover

ONE FULL YEAR WARRANTY ON CRAFTSMAN

PROFESSIONAL TWIN CUTTER SAW

If this product fails due to a defect in material or workmanship within one year from the date of purchase, RETURN ITTO THE NEAREST SEARS PARTS AND REPAIR CENTER INTHE UNITED STATES, and it will be repaired, free of charge.

This warranty gives you specific legal rights, and you may also have other rights which vary from stale to state.

Sears, Roebuck and Co. Dept. 817 WA, Hoffman Estates, IL 60179

SAVE THESE INSTRUCTIONS!

READ ALL INSTRUCTIONS!

			"--------3
WARNING:		RE SURE to read and understand all instructions.	Failure to	I
follow	all instructions listed below may result in electric shock, fire		and/or	I
serious	personal	injury.

WORK AREA SAFETY

t. ALWAYS keep your work area clean and well lit. Cluttered benches and dark areas invite accidents.

2.DO NOT operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust. Power tools creale sparks which

may ignite the dust or fumes.

3.ALWAYS keep bystanders, children, and visitors away while operating a power tool. Distractions can cause you to lose control

ELECTRICAL SAFETY

1.Double insulated tools are equipped with a polarized plug (one blade is wider than the other.) This plug will fit in a polarized outlet only one way.

If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install a polarized outlet. Do not change the plug in atry way.

2.Double insulation []eliminates the need for the three-wire grounded power cord and grounded power supply system, Applicable only to Class II (double insulated) tools.

3.Before plugging in the tool, BE SURE that the outlet voltage supplied is within the voltage marked on the tool'sdata plate. DO NOT use "AC only" rated tools with a DO power supply.

4.ALWAYS avoid body contact with grounded surtaees, such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is grounded.

5.If operating the power tool in damp locations is unavoidable, ALWAYS use a

Ground Fault Circuit Interrupter to supply power to your tOOl. ALWAYS wear electrician's rubber gloves and footwear in damp conditions.

6.DO NOT expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of eleclric shock.

7.DO NOT abuse the cord. NEVER use the cord to carry the tools or pull the plug from the outlet. Keep cord away from heat, oil, sharp edges or moving parts. Replace damaged cords immediately. Damaged cords increase the risk of electric shock.

8.When operating a power tool outside, ALWAYS use an outdoor extension cord marked "W-A" or"W". These cords are rated for outdoor use and reduce the risk of electric shock.

NOTE: The extension cord must have adequate wire size AWG (American Wire Gauge) for safe, efficient use. Smaller gauge wires, have greater capacity (16 gauge wire has more capacity than 18 gauge wire).

2 3