_ WARNING: Always wear safety goggles or safety glasses with side shields when operating tools. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury.
WARNING: Do not allow familiarity with your ddll to make you careless. Remember that a
careless fraction of a second is sufficient to inflict severe injury.
CHARGING BA'I'rERYPACK
The battery pack for this tool has been shipped in a low charge condition to prevent possible problems.
Therefore, you should charge it at least 5 hours pdor to use.
Note: Batteries will not reach full charge the first time they are charged. Allow several cycles (drilling followed by recharging) for them to become fully charged.
TO CHARGE
•Charge battery pack only with the charger and charging stand provided.
•Connect charger to charging stand by inserting charger plug into input jack.
•Make sure power supply is normal house voltage, 120 volts, 60 Hz, AC only.
•Connect charger to power supply.
•Place battery pack in charging stand. Align raised rib on battery pack with groove in charging stand. See Figure 1.
•Press down on battery pack to be sure contacts on battery pack engage propedy with contacts in charging stand.
•When properly connected, the red light on charging H stand will turn on.
•Note: Ifcharger does cot d'_'geIoatterypack, re_um battery I_P,, charging stand, and charger to your nearest Sears Repair Centerfor electdcalcheck.
•Alter normalusage, 5 houmof charging_me is requirsd to be fullycharged.A minimumchargelime of 5 hoursis requiredto rechargea completelydischargedtool.
•The battery pack will become slightly warm to the touch while charging. This is normal and does not indicate a problem.
•Do not place charger in an area of extreme heat or cold. It will work best at normal room temperature.
CAUTION: Your battery pack contains special high temperature batteries to help prevent battery
damage when left on charge for extended periods of time. However, once the batteries become fully charged, we recommend that you unplug your charger from power supply and remove the battery pack.
7