Craftsman 315.113911 Shownin Charger, Redled on Indicates, Greenledon Afterfast Charging

BATTERY

PACK/CHARGER

[]

If both

yellow

and green LED come

on, this

The battery

pack

and charger are not included

with

indicates a deeply

discharged

or defective

battery

your worklight. They are both sold separately. When

pack.

purchasing,

use the following

information:

Allow battery pack to remain

in charger for 15 to

MODEL

NO.

BATTERY PACK

CHARGER

30 minutes. When battery pack reaches normal

973.113911

item No. _911375

item

No. _911041

voltage

range, red LED should come on.

(1323517 or 1323903)

(1425301)

If red LED does not come

on after 30 minutes,

this

BATTERY

PACK

indicates a defective

battery

pack and should

be

The battery

pack

for your worklight

has been shipped

replaced.

in a low charge

condition

to

prevent

possible

prob-

[]

After normal

usage,

a minimum

of 1 hour

of

lems. Therefore,

you should

charge

it until light

on

charging time

is required to fully

recharge

battery

front

of charger

changes

from red to green.

pack.

Note: Batteries

will not reach full charge the first time

[]

The battery

pack

will

become

slightly warm to

the

they

are charged.

Allow

several

cycles (operating

touch while

charging.

This

is normal

and does

not

worklight

followed

by recharging) for batteries

to

indicate

a problem.

become

fully

charged.

[]

Do not

place charger

and

battery pack in an area

CHARGING

BATTERY

PACK

of extreme

heat or cold. It will work

best at normal

See Figure

1.

room temperature.

Note: Charger and battery pack should be placed

[]

Use only the

recommended

battery pack

and

in a location where the temperature is more than

charger

with

your worklight.

50°F but less than 100°R

[]

Make sure

power supply

is normal

household

[]

When batteries become fully

charged, unplug

voltage,

120 volts,

60 Hz,

AC only.

charger from power supply and remove the bat-

[]

Connect

charger to power

supply.

tery pack.

[]

Place battery

pack in charger aligning

raised

iNFORMATION

FOR

RECHARGING

HOT

rib on battery pack with groove in charger.

BATTERY

PACK

See Figure

1.

[]

Press down

on battery pack to be sure contacts

When

using your

worklight continuously,

the batteries

on battery pack engage properly with

contacts in

in your

battery

pack will

become

hot. You should let a

charger.

hot battery

pack

cool down for approximately

30 min-

[]

Normally,

the red LED on charger will come

on.

utes before attempting to recharge. When the battery

pack becomes discharged and is hot, this will cause

This indicates charger is in fast charging mode.

the green LED to come on instead of the red LED.

[]

Red LED should remain

on for approximately

1

After 30 minutes, reinsert battery pack in charger. If

hour then the green LED will come on. Green LED

green LED continues to remain on, return battery pack

on indicates battery pack is fully charged and

to your nearest Sears Repair Center for checking or

charger is in trickle charge mode. Note: Green

replacing.

LED will remain on until battery pack is removed

Note: This situation only occurs when continuous

from charger or charger is disconnected from

use of your worklight causes the batteries to become

power supply.

hot. It does not occur under normal circumstances.

BATTERYPACK

Refer to "CHARGING

BATTERY

PACK"

for normal

SHOWNIN CHARGER

recharging

of batteries.

If the charger does not charge

	your battery pack under normal circumstances, return
CHARGER	both the battery pack and charger to your nearest
	Sears Repair Center for electrical check.

REDLED ON INDICATES

FASTCHARGINGMODE

GREENLEDON AFTERFAST CHARGING

CYCLE,iNDICATESFULLYCHARGEDBATTERY

PACKANDIN TRICKLECHARGEMODE.

YELLOWANDGREENLED8

ON INDICATESDEEPLY

Fig. 1