TO INSTALL BATTERY PACK
•Place battery pack in your tool. Align raised rib on battery pack with groove inside toot. See Figure 2.
•Make sure the latches on each side of your battery pack snap in place and battery pack is secured in toot before beginning operation.
BATTERY
LATCHES
DEPRESSLATCHESTO
RELEASEBATTERYPACK
Fig. 2
_k CAUTION: When placing battery pack in the tool, be sure raised rib on battery pack aligns with groove
inside tool and latches snap into place properly. Improper assembly of battery pack can cause damage to internal components.
•Place staples in channel, legs facing upward and close base or drop nails in, left side of channel with "T" head sitting on the slot base. Close base while making sure nail strip stays upright in channel.
•Make sure that the latch is securely locked is place.
•Reattach battery pack to tool.
LATCH
Fig. 3
TO REMOVE BATTERY | PACK |
|
• Locate latches on side | of battery pack and depress to | STAPLES |
release battery pack from the tool. See Figure 2. |
| |
•Remove battery pack from the tool.
LOADING THE TOOL
See Figure
•Remove battery pack from the toot. WARNING:
,_ WARNING: Always wear safety googles or safety glasses during powertoot operation or when blow- ing dust. If operatin is dusty, also wear a dust mask.
,_ WARNING: Always remove battery pack from the tool when you are assembling parts, making adjust-
ments, assembling or removing blades, cleaning, or when not in use. Removing battery pack will prevent accidental starting that could cause serious personal injury.
•Hold tool upside down; squeeze latch and slide base open.
11
