TO ATTACH BATTERY PACK TO DRILL
See Figure 5.
Note: Battery pack is shipped in a low charge condition. Therefore, it must be charged prior to use. Refer to page 10, "CHARGING BATTERY PACK" for charging instructions.
•Lock the switch trigger by placing the direction of rotation selector in center position. See Figure 10.
•Align raised ribs on battery pack with grooves on bottom of drill, then attach battery pack to drill as shown in Figure 5.
•Make sure latch on battery pack snaps in place and battery pack is secured to drill before beginning operation.
(_CX]VES
BA_ PACK
Fig. 5
_1= CAUTION: When attaching battery pack to your drill, be sure raised ribs and grooves align properly
and latch snaps in place properly. Improper assembly can cause damage to drill and battery pack.
TO REMOVE BATTERY PACK FROM DRILL
See Figure 6.
•Lock the switch trigger by placing the direction of rotation selector in center position. See Figure 10.
•Depress latch located on front of battery pack (1) to release battery pack.
•Pull forward on battery pack (2) to remove from drill.
PUlJ_
TORBVlOVE
Fig. 6
