GUIDE BAR MAINTENANCE:
Most guide bar probbms can be prevented merely by keeping the chain saw weHHmaintained,
insufficient guide bar lubrication and operating the saw with chain that is too tight wiHHcontribute to rapid bar wear,
To help minimize bar wear, the foHHowingguide bar mainte- nance procedures are recommended,
BAR WEAR - Turn guide bar frequently at regular intervals (for example, after 5 hours of use), to ensure even wear on top and bottom of bar,
BAR GROOVES (B) Bar grooves (or rails which support and carry the chain) should be cleaned if saw has been used heavily or if saw chain appears dirty, Raid should always be cbaned every time saw chain is removed,(fig, 38)
OIL PASSAGES (A) Oil passages on the bar should be cleaned to ensure proper lubrication of the bar and chain during operation, This can be done using a soft wire small enough to insert into the oil discharge hob.(fig, 38)
Fig. 38
NOTE: The condition of the oil passages can be easily' checked, if the passages are clear, the chain will automatically give off a spray of oil within seconds of starting the saw, Your saw is equipped with an automatic oiler system,
CHAroN MAINTENANCE
Chain Tension
Check the chain tension frequently and adjust as often as necessary to keep the chain snug on the bar, but loose enough to be pulled around by hand,
Breaking in a New Saw Chain
A new chain and bar will need chain readjustment after as few as 5 cuts, This is normal during the
WARNING: Neverhavemore
than 3 links removed
from a Hoop of chain. This could cause dam- age to the sprocket.
Chain Lubrication
Always make sure the automatic oiler system is working properly. Keep the oil reservoir filled with Chain, Bar and Sprocket Oil,
Adequate lubrication of the bar and chain during cutting oper- ations is essential to minimize friction with the guide bar,
Never starve the bar and chain of lubricating oil, Running the saw dry or with too little oil will decrease cutting effi- ciency, shorten saw chain life, cause rapid dulling of chain, and Headto excessive wear of bar from overheating. Too little oil is evidenced by smoke or bar discoloration,
Chain Sharpening
Chain sharpening requires special tools to ensure that cut- ters are sharpened at the correct angle and depth, For the inexperienced chain saw user, we recommend that the saw chain be professionally sharpened by the nearest
Authorized Service Center, If you feel comfortable sharp- ening your own saw chain, special tools are available from your Authorized Service Center,
CHAIN REPLACEMENT iNFORMATiON
Bar18"LengthBar _ Drive72 LinksDL I Sears36514Part #
iNERTiA CHAIN BRAKE® ACTION
NOTE: THIS SAW iS EQUIPPED WITH AN INERTIA CHAIN BRAKE. IF THE SAW KICKS BACK WHILE IN USE, THE iNERTIA OF THE MOVING SAW WILL ACTIVATE THE BRAKE, A BRAKE BAND AROUND THE CLUTCH DRUM ACTIVATES AND STOPS THE MOVING CHAIN,
21
