Craftsman 316.792490 manual Adjustment Bolt

Gear Housing

Drive Shaft

Assembly

indexing Ring

Adjustment Bolt

Blade

Hanger

Adjustment

Angle

Handle

iNSTALLiNG / REMOVING THE ATTACHMENT

	I for unit to be used with this attachment prior to
	WARNING:	Read and understand operator's manual
	operation.
	damage to the unit, shut unit off before removing or
_	I WARNING:installing attachmentsToavoid. serious personal injury and

I

Installing the attachment:

NOTE: To make installing or removing the attachment easier, place the unit on the ground or on a work bench.

1.Remove the hanger from the top of the shaft housing.

2.Turn knob counterclockwise to loosen (Fig. 1).

J

Loosen

Tighten L Knob

Fig. I

3.While firmly holding the attachment, push it straight into the coupler until the release button snaps firmly into the primary hole (Fig. 2).

NOTE: Aligning the release button with the guide recess will help installation (Fig. 3).

hole (Fig. 2) and securely tighten the knob before

loperatingCAUTION: this unitLock. the release button in the primary

this product. It is not designed to be used with an extensionWARNING: and usingDO NOTone USEmay ancauseextensionseriousboominjurywith.

Craftsman Convertible TM Release Button

Primary \ Hole

Upper Shaft		v/1 _	v	Lower	Shaft
Housing		Knob _		Housing
		Fig.	2
Craftsman	Convertible	TM
	Coupler	Release	Button	Guide	Recess

Fig. 3

4.Turn the knob clockwise to tighten (Fig. 1).

are to be used in the primary hole only. Using the wrong holeCAUTION:could leadTheto personalattachmentsinjurywithor damagethecouplerto thesystemunit.