3.Pull starter rope with a controlled and steady motion until engine runs, but no more than 6 pulls.
4.Allow engine to run 15 seconds, then move the choke lever to RUN.
NOTE: If engine has not started, pull starter rope 5 more pulls. If engine still does not run, it is probably flooded.
STARTING A FLOODED ENGINE
Flooded engines can be started by plac- ing the choke lever in the RUN position; then, pull the rope to clear the engine of excess fuel. This could require pulling the starter handle many times depend- ing on how badly the unit is flooded. If
the unit still doesn't start, refer to TROUBLESHOOTING TABLE or call
CUSTOMER RESPONSIBILITIES
WARNING; Disconnect the spark plug before performing maintenance,
service, or adjustments.
CARE & MAINTENANCE TASK
Check for loose fasteners and parts
Check for damaged or worn parts
Inspect and clean unit and labels Clean air filter
Replace spark plug
Replace fuel filter
Check muffler mounting screws
,_" WARNING: Avoid touching muf- fler unless engine and muffler are cold. A hot muffler can cause serious burns.
_WARNING: | Stop engine and be |
sure the impeller blades have stopped turning before opening the vacuum in-
let door or attempting to insert or re- move the vacuum or blower tubes.
The rotating blades can cause serious injury. Always disconnect the spark plug before performing maintenance or accessing movable parts.
GENERAL RECOMMEN DATIONS
The warranty on this unit does not cov- er items that have been subjected to operator abuse or negligence. To re- ceive full value from the warranty, the operator must maintain unit as instruct- ed in this manual. Various adjustments will need to be made periodically to properly maintain your unit.
WHEN TO PERFORM
Before each use
Before each use
After each use
Every 5 hours of operation
Yearly
Yearly
Yearly
CHECK FOR LOOSE
FASTENERS AND PARTS
•Muffler
•Spark Plug Boot
•Air Filter
•Housing Screws
CHECK FOR DAMAGED OR WORN PARTS
Contact Sears Service Center for re- placement of damaged or worn parts.
•Throttle Lever - Ensure throttle lever functions properly by moving the throttle lever to the STOP position. Make sure engine stops; then restart engine and continue.
•Fuel Tank - Do not use unit if fuel tank shows signs of damage or leaks.
•Vacuum Bag - Do not use vacuum
bag if it is torn or damaged.
INSPECT AND CLEAN UNIT AND LABELS
•After each use, inspect complete unit for loose or damaged parts. Clean the unit using a damp cloth with a mild detergent.
•Wipe off unit with a clean dry cloth.
