CARTON CONTENTS
Check carton contents against the fol-
lowing list.
Model 358.794740
•Blower
•Upper blower tube
•Lower blower tube
•High velocity nozzle
•Elbow tube
•Vacuum bag
•Upper vacuum tube
•Lower vacuum tube
•
NOTE: It is normal for the fuel filter to rattle in the empty fuel tank.
ASSEMBLY
_WARNING: | Stop engine and be |
sure the impeller blades have stopped turning before opening the vacuum in- let door or attempting to insert or re- move the vacuum tubes. The rotating blades can cause serious injury.
WARNING: | If you | receive | your |
unit assembled, | repeat | all steps | to en- |
sure your unit is properly assembled and all fasteners are secure.
•A standard screwdriver is required for assembly.
BLOWER ASSEMBLY
BLOWER TUBE ASSEMBLY
If you have already assembled your unit for use as a vacuum, remove the
vacuum tubes and collection bag.
1.Align the slots on the lower blower
tube with the tabs on the upper blower tube.
Upper Blower Tube
2.Slide the lower blower tube onto the upper blower tube.
3.Turn the lower blower tube clock- wise until a click is felt to secure
the lower blower tube to the upper blower tube.
4.Align the rib on the upper blower tube with the groove in the blower outlet; slide the tube into place.
NOTE: Knob must be loose enough to allow blower tubes to be inserted in
blower outlet. Loosen knob by turning counterclockwise.
_ | Blower Outlet |
R'b
5.Secure the tubes by turning the knob clockwise.
6.To remove the tubes, turn the knob
counterclockwise to loosen the
tubes; remove the tubes.
HIGH-SPEED NOZZLE ASSEMBLY
When greater air speed is desired, use the
1.Align the slots on the nozzle with the tabs on the lower blower tube.
| |||
_ | _,_ | __, | Nozzle |
Lower Blower | Tab/ | ||
Tube |
|
| Slot |
2.Slide the nozzle onto the lower blower tube.
3.Turn the nozzle clockwise until a click is felt to secure the nozzle to the lower blower tube.
VACUUM BAG ASSEMBLY
1.Open the zipper on the vacuum bag and insert the elbow tube.
2.Push the small end of the elbow tube through the small opening in the bag.
Rib
Opening
Small Opening
NOTE: Make sure edge of the small opening is flush against the flared area of the elbow tube, and the rib on the elbow tube is on the bottom.
3.Close the zipper on the bag. Make sure the zipper is closed completely.
4.Remove blower tubes from engine.
