Craftsman 358.794740 manual Operating Position, Before Starting Engine, Fueling Engine

Models: 358.794740

1 40
Download 40 pages 27.61 Kb
Page 10
Image 10

Watch out for children, pets, open windows, or freshly washed cars. Blow debris away safely.

Use the full blower nozzle extension so the air stream can work close to

the ground.

After using blowers and other equip-

ment, CLEAN UP! Dispose of debris in trash receptacles.

OPERATING POSITION

IMPORTANT

Experience indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract mois- ture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel sys- tem of an engine while in storage.

To avoid engine problems, empty the fuel system before storage for 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

BlowerVacuum

BEFORE STARTING ENGINE

_L'WARNING: Be sure to read the

fuel information in the safety rules before you begin. If you do not understand the safety rules, do not

attempt to fuel your unit. Call 1-800-235-5878.

FUELING ENGINE

_f_,WARNING: Remove fuel cap

slowly when refueling.

This engine is certified to operate on un- leaded gasoline. Before operation, gaso- line must be mixed with a good quality synthetic 2-cycle air-cooled engine oil. We recommend Craftsman brand syn-

Fuel stabilizer is an acceptable alter- native in minimizing the formation of fuel gum deposits during storage.

Craftsman brand oil is already blended with fuel stabilizer. See the STORAGE section for additional information.

HOW TO STOP YOUR ENGINE

Release the throttle trigger.

Push and hold the STOP switch in

the STOP position until the engine stops.

HOW TO START YOUR ENGINE

,_ WARNING: You MUST make sure

the tubes are secure before using the unit.

Fuel engine. Move at least 10 feet (3 meters) away from the fueling site.

Hold the unit in the starting position as shown. Make sure the blower end

is directed away from people, ani- mals, glass, and solid objects.

STARTING POSITION

Blower

thetic oil. Mix gasoline and oil at a ratio of 40:1. A 40:1 ratio is obtained by mix- ing 3.2 ounces of oil with 1 gallon of un- leaded gasoline. Included with this blow- er is a 3.2 ounce container of oil. Pour the entire contents of this container into

1 gallon of gasoline to achieve the prop- er fuel mixture. DO NOT USE automotive

oil or boat oil. These oils will cause en- gine damage. When mixing fuel, follow instructions printed on container. Once oil is added to gasoline, shake container momentarily to assure that the fuel is thoroughly mixed. Always read and fol- low the safety rules relating to fuel be- fore fueling your unit.

-10-

A

WARNING: When starting engine, hold the unit as illustrated. Do not set

unit on any surface except a clean, hard area when starting engine or while en- gine is running. Debris such as gravel, sand, dust, grass, etc. could be picked

Page 10
Image 10
Craftsman 358.794740 manual Operating Position, Before Starting Engine, Fueling Engine, HOW to Stop Your Engine