BLOWER ASSEMBLY
BLOWER TUBE ASSEMBLY
If you have already assembled your unit for use as a vacuum, remove the vacuum tubes and collection bag.
1.Align the slots on the lower blower tube with the tabs on the upper blower tube.
Upper Blower Tube
Lower Blower Tube
Slot
2.Slide the lower blower tube onto the upper blower tube.
3.Turn the lower blower tube clock- wise until a click is felt to secure
the lower blower tube to the upper blower tube.
NOTE: When the upper and lower blower tubes are assembled together properly, the arrows on both tubes will be aligned.
Nozzle
Lower Blower
Tube
2.Slide the nozzle onto the lower blower tube.
3.Turn the nozzle clockwise until a click is felt to secure the nozzle to the lower blower tube.
VACUUM ASSEMBLY
VACUUM BAG ASSEMBLY
1.Open the zipper on the vacuum bag and insert the elbow tube.
2.Push the small end of the elbow
tube through the small opening in the bag.
Elbow Tube | Rib |
|
4.Align the rib on the upper blower tube with the groove in the blower outlet; slide the tube into place.
NOTE: Knob must be loose enough to allow blower tubes to be inserted in blower outlet. Loosen knob by turning counterclockwise.
Blower Outlet
c
Groove
5.Secure the tubes by turning the knob clockwise.
6.To remove the tubes, turn the knob counterclockwise to loosen the tubes; remove the tubes.
HIGH-SPEED NOZZLE ASSEMBLY
When greater air speed is desired, use the
1.Align the slots on the nozzle with the tabs on the lower blower tube.
Opening
Small Opening
NOTE: Make sure edge of the small opening is flush against the flared area of the elbow tube, and the rib on the elbow tube is on the bottom.
3.Close the zipper on the bag. Make sure the zipper is closed completely.
4.Remove blower tubes from engine.
5.Insert the elbow tube into the blow- er outlet. Make sure elbow tube rib
is aligned with the blower outlet groove.
6.Turn knob clockwise to secure el- bow tube.
VACUUM TUBE ASSEMBLY
_WARNING: | Stop engine and be |
sure the impeller blades have stopped turning before opening the vacuum inlet
