Craftsman 358.794772 manual Blower Assembly Blower Tube Assembly, HIGH-SPEED Nozzle Assembly

WARNING:	If you	receive	your
unit assembled,	repeat	all steps	to en-

sure your unit is properly assembled and all fasteners are secure.

A standard screwdriver is required for assembly.

BLOWER ASSEMBLY

BLOWER TUBE ASSEMBLY

If you have already assembled your unit for use as a vacuum, remove the vacuum tubes and collection bag.

1.Align the rib on the upper blower tube with the groove in the blower outlet; slide the tube into place.

NOTE: Knob must be loose enough to allow blower tube to be inserted in

biower outlet. Loosen knob by turning counterclockwise.

_ B_owerOutlet

_ _' \" Rib

v_s:_:-_" Groove

2.Secure the tube by turning the knob clockwise.

3.Align the slots on the lower blower

tube with the tabs on the upper blower tube.

Tab

Lower Blower Tube

4.Slide the lower blower tube onto the upper blower tube.

5.Turn the lower blower tube clock- wise until a click is felt to secure

the lower blower tube to the upper blower tube.

NOTE: When the upper and lower blower tubes are assembled together properly, the arrows on both tubes witt be aligned.

6.To remove the tubes, turn the knob counterclockwise to loosen the tubes; remove the tubes.

HIGH-SPEED NOZZLE ASSEMBLY

When greater air speed is desired, use the high-speed nozzle.

1.Align the slots on the nozzle with the tabs on the lower btower tube.

High-Speed

Nozz{e

i

Lower Blower

Tube

2.Slide the nozzle onto the lower blower tube.

3.Turn the nozzle clockwise untit a click is felt to secure the nozzle to the lower blower tube.

VACUUM ASSEMBLY

VACUUM BAG ASSEMBLY

1.Open the zipper on the vacuum bag and insert the elbow tube.

2.Push the small end of the elbow

tube through the small opening in the bag.

Elbow Tube

Rib

Opening'_ Small Opening

NOTE: Make sure edge of the small opening is flush against the flared area

of the elbow tube, and the rib on the elbow tube is on the bottom.

3.Close the zipper on file bag. Make sure the zipper is closed completely.

4.Remove blower tubes from engine.

5.Insert the elbow tube into the blow- er outlet. Make sure elbow tube rib is aligned with the biower outlet groove.