6.Turnknobclockwisetosecureel- bowtube.
VACUUMTUBEASSEMBLY
_WARNING:Stopengineandbe suretheimpellerbladeshavestopped turningbeforeopeningthevacuuminlet doororattemptingtoinsertorremove thevacuumorblowertubesTherotat.- ingbladescancauseseriousinjury.
1. Insertthetipofascrewdriverinto
the latch area of the vacuum inlet. LatchA_ea q Blower
5.Push the upper vacuum tube into the vacuum inlet. Tum the tube counterclockwise until a click is felt to secure the tube to the blower unit.
6.Align slanted end of lower vacuum tube as shown. Firmly push lower
vacuum tube into upper vacuum tube.
Vacuum Inlet Cover
2.Gently tilt the handle of the screw- driver toward the front of the unit to
release the latch while pulling up on the vacuum inlet cover with your other hand.
3.Hold the vacuum inlet cover open until upper vacuum tube is installed.
Vacuum
Inlet
Cover
/
/
Inlet
4.Align the tabs on the inside of the vacuum inlet with the slots in the
upper vacuum tube.
({
Tab sl0t
Slanted end of
HOW TO CONVERT UNIT FROM VACUUM USE TO BLOWER USE
1.Remove the elbow tube and vacu-
um bag by turning the knob coun- terclockwise to loosen the elbow
tube.
2.Remove the vacuum tubes by turn-
ing the tubes clockwise.
3, Close the vacuum inlet cover and
make sure it is latched closed.
4.Reinstall the blower tubes (see
BLOWER TUBE ASSEMBLY).
VACUUM BAG SHOULDER STRAP
ADJUSTMENT
1.Hold the unit as shown with the
muffler side facing away from your body and clothes.
2.Pass the shoulder strap over your head and onto your right shoulder.
3.Extend your left arm toward the rear of the vacuum bag.
4.Adjust shoulder strap unffl the vacu- um bag/shoulder strap seam lies be- tween your thumb and index finger.
5.Make sure air flows freely from the elbow tube into bag. If bag is kinked, the unit will not operate properly.