Craftsman 358.794941 instruction manual Carton Contents, Blower Assembly Blower Tube Assembly

•Empty fuel tank before storing the unit. Use up fuel left in carburetor by starting engine and letting it run until it stops.

•Do not use any accessory or attach- ment other than those recommended

by manufacturer for use with your unit.

•Do not store the unit or fuel in a closed area where fuel vapors can reach sparks or an open flame from hot water heaters, electric motors or switches, furnaces, etc.

•Store in a dry area out of reach of children.

SAFETY NOTICE: Exposure to vibra- tions through prolonged use of gaso- line powered hand tools could cause blood vessel or nerve damage in the fingers, hands, and joints of people prone to circulation disorders or abnor- mal swelling. Prolonged use in cold weather has been linked to blood ves- sel damage in otherwise healthy people. If symptoms occur such as numbness, pain, loss of strength, change in skin color or texture, or loss of feeling in the fingers, hands, or joints, discontinue the use of this tool and seek medical attention. An

antivibration system does not guaran- tee the avoidance of these problems.

CARTON CONTENTS

Check carton contents against the fol-

lowing list.

Model 358.794941

•Blower

•Blower tube

•Elbow tube

•Vacuum bag

•Upper vacuum tube

•Lower vacuum tube

•2-Cycle engine oil

NOTE: It is normal for the fuel filter to rattle in the empty fuel tank.

ASSEMBLY

_.WARNING: Stop engine and be

sure the impeller blades have stopped turning before opening the vacuum in- let door or attempting to insert or re- move the vacuum tubes. The rotating blades can cause serious injury.

Users who operate power tools on a

continual and regular basis must moni- tor closely their physical condition and the condition of this tool.

SPECIAL NOTICE: For users on U.S. Forest Land and in some states, includ-

ing California (Public Resources Codes 4442 and 4443), Idaho, Maine, Minne-

sota, New Jersey, Oregon, and Wash- ington: Certain internal combustion en- gines operated on forest, brush, and/or grass covered land in the above areas are required to be equipped with a spark arresting screen, maintained in effective working order, or the engine must be constructed, equipped, and maintained for the prevention of fire. Check with your state or local authorities for regula- tions pertaining to these requirements. Failure to follow these requirements is a violation of the law. This unit is not facto- ry equipped with a spark arresting

screen; however, a spark arresting screen is available as an optional part. If a spark arresting screen is required in your area, contact Sears Service for the correct kit. The spark arresting screen, blower tubes, and nozzles must be as- sembled to unit to be in full compliance with regulations.

sure your unit is properly assembled and all fasteners are secure.

•A standard screwdriver is required for assembly.

BLOWER ASSEMBLY

BLOWER TUBE ASSEMBLY

If you have already assembled your unit for use as a vacuum, remove the vacuum tubes and collection bag.

1.Align the rib on the blower tube with the groove in the blower outlet; slide the tube into place.

NOTE: Knob must be loose enough to allow blower tube to be inserted in blow-

er outlet. Loosen knob by turning coun- terclockwise.

17'_ _	Blower	Blower
	Ootlet
£,_'_-_,,q,'_	./	Tube

,_ WARNING:	If you	receive your	_Groove _ _	Rib
unit assembled,	repeat	all steps to en-

-4-