Craftsman 358.794941 Shoulder Strap Adjustment for vacuum use only, Throttle Lever, Primer Button

3. Extend your left arm toward the rear of the vacuum bag.

4. Adjust shoulder strap until the vac- uum bag/shoulder strap seam lies between your thumb and index finger.

5. Make sure air flows freely from the elbow tube into bag. If bag is kinked, the unit will not operate properly.

3.Remove the vacuum bag.

4= Close the vacuum inlet cover and

make sure it is latched closed. 5= Reinstallthe blowertube (see

BLOWER TUBE ASSEMBLY).

SHOULDER STRAP ADJUSTMENT (for vacuum use only)

1.Hold the unit as shown with the

muffler side facing away from your body and clothes.

2= Pass the shoulder strap over your head and onto your right shoulder.

KNOW YOUR BLOWER

READ THIS iNSTRUCTiON MANUAL AND SAFETY RULES BEFORE OPERATING YOUR

UNIT. Compare the illustrations with your unit to familiarize yourself with the location

of the various controls and adjustments. Save this manual for future reference. Upper

Vacuum	Tube
Lower	Vacuum T_

Primer Button

Choke Lever

Fuel Mix

Throttle

Lever

Fill Cap

	Starter
Elbow Tube	Rope

Blower

Tube

Rear

Handle

THROTTLE LEVER

The THROTI-LE LEVER is used to select the desired engine speed and to stop the engine. Move the throttle lever to the '{_ position for full speed operation.

Move the throttle lever to the _ posi- tion for idle speed. To stop the engine,

move the throttle lever to the STOP posi- tion.

PRIMER BUTTON

The PRIMER BUqq-ONremoves air from the carburetor and fuel lines and fills

them with fuel. This allows you to start the engine with fewer pulls on the starter rope. Activate primer button by pressing it and allowing it to return to its original position.

-6-