ASSEMBLY
TOOLS REQUIRED FOR ASSEMBLY
(2)7/16" Wrenches
(2)1/2" Wrench
(1)Pliers
(1)Hammer
STEP 1: (SEE FIGURE 1)
•Install a
25 | 43 | 4 |
| ||
|
|
39
FIGURE 1
STEP 2: (SEE FIGURE 2)
•Slide the bag arm channels (4) into the sweeper housing as shown in figure 2. Secure them to the sweeper housing with a
15
4
21
STEP 3: (SEE FIGURE 3)
•Secure each bag arm channel to the side of the sweeper housing with a wing nut (31) and a washer (43) installed on the bolt assembled in step 1.
•Insert a pivot rod retainer (30) down into the end of each bag arm channel.
•Install a compression spring (32) into the bottom of each of the pivot rod retainers to secure them to the bag arm channels.
30
32
43
31
FIGURE 3
STEP 4: (SEE FIGURE 4)
•Attach the drawbar (14) to the sweeper by fastening a drawbar bracket (8) above and below the drawbar using two washers (68), three 5/16" x
15
8
68
14
68 8
21
FIGURE 2 | FIGURE 4 |
5