STEP 13: (SEE FIGURE 13)

1.Secure the top and bottom hopper tubes together using two 5/16" x 3/4" hex bolts (17) on inside the hopper bag and two 5/16" nylock nuts (21) outside.

21

17

17

21

FIGURE 13

STEP 14: (SEE FIGURE 14)

•Slide the dump handle clip (33) onto the dump handle.

•Attach the dump tube to the rear hopper tube using a U-clamp (34), a 1/4" x 1-1/2" hex bolt (16) and a 1/4" nylock nut (24). Install the U-clamp between the washers and cotter pins.

•Swivel the dump tube so that the end of the tube rests on the ground behind the bag and supports the rear of the bag in an upright position.

STEP 15: (SEE FIGURE 15)

•Insert the hopper support rods (7) into the hole beneath the curved head bolt (26) in each upper hopper tube. Flex and insert the rod into the hole in the bottom rear hopper tubes as shown.

NOTE: The hopper support rods will flex about as much as shown in figure 15 when they are assembled.

26

7

7

7

FIGURE 15

STEP 16: (SEE FIGURE 16)

•Slide the pivot rod (2) through the flap in the bag's windscreen first and then through the hole in each upper hopper tube.

•Hammer a palnut (23) onto each end of the pivot rod. HINT: Place the bag on its side on a hard surface to make installation of palnuts easier.

24

2

34

23

16

 

5

33

FIGURE 14

FIGURE 16

8