Craftsman 486.24029 STEP 9:, STEP 10:, STEP 11:, STEP 12:, NOTE:, FIGURE, FIGURE, FIGURE, FIGURE, STEP 9: (SEE FIGURE 9), STEP 10: (SEE FIGURE 10), STEP 11: (SEE FIGURE 11)

STEP 9: (SEE FIGURE 9)

•Slide the front flaps of the hopper bag up onto the front of the lower hopper tubes. Secure the bag frame tube to the lower hopper tubes using two clevis pins (28) and small hairpin cotters (19).

NOTE: Be sure front flaps of hopper bag are positioned above clevis pins.

•Snap the sides of the bag to the bottom of the bag at the front corners .

19

28

FIGURE 9

STEP 10: (SEE FIGURE 10)

•Place two washers (42) between the middle holes in a rear hopper tube (11). Install two cotter pins (27) into the holes, spreading the ends around the tube.

•Assemble the rear hopper tube (11) to the two upper hopper tubes (6) using two 1/4" x 1" curved head bolts (26) and 1/4" nylock nuts (24). The bolt heads should face up as shown in figure 10.

26 42

11

	24
6	27
		26

24

6

FIGURE 10

STEP 11: (SEE FIGURE 11)

•Slide the assembled tubes down through the flaps in the sides of the hopper bag (3) as shown.

FIGURE 11

STEP 12: (SEE FIGURE 12)

•Slide the assembled tubes back up underneath the wind screen as shown.

FIGURE 12

7