•Secure the bag corners around the lower hopper tubes by snapping the bag fl aps to the bag bottom. See fi gure 15.
SNAP | FLAP |
|
FIGURE 15
•Insert the hopper bag rod through the upper hole in the upper hopper tubes and the through the stitched sleeve at the front of the wind screen. See fi gure 16.
•Assemble two palnuts by lightly tapping them onto the ends of the pivot rod with a hammer. See fi gure 16.
HINT: To ease assembly of the palnuts, place the bag on its side on a hard surface. With the bottom end of the pivot rod against the surface, tap a palnut onto the top end of the rod. Repeat for other end of rod.
HOPPER
BAG ROD
WIND SCREEN 
PALNUT
UPPER HOLE
IMPORTANT: Do not over bend the support rods during the following step. Over bending will cause the spring steel rods to loose supporting tension.
•Assemble the two hopper support rods as shown in fi gure 17. Place the ends of the rods into the upper and lower hopper tubes, bending the rod just enough to fi t into the holes in the tubes.
SUPPORT
RODS
FIGURE 17
•Align two hopper mount clamps with the lower hole in each upper hopper tube. Insert a 3/8" x 3" clevis pin through the clamps and the upper hopper tube. Assemble a bag arm tube onto the clevis pin and secure it with a 3/32" hair cotter pin. See fi gure 18.
•Assemble a vinyl cap onto each bag arm tube as shown in fi gure 18.
HOPPER
MOUNT
CLAMPS
VINYL CAP
3/8" x 3"
CLEVIS PIN
3/32" HAIR
COTTER PIN
BAG ARM TUBE 
FIGURE 16 | FIGURE 18 |
|
8
