ASSEMBLY

TOOLS REQUIRED FOR ASSEMBLY

(1)Hammer

(2)1/2" Wrenches

(2)7/16" Wrenches

STEP 1 - REMOVE PARTS FROM CARTON

•To protect painted parts, lay them on cardboard or a mat.

•Remove the sweeper housing, the loose parts and the hardware package from the carton. Lay out the parts and hardware as shown on pages 3 and 4.

•Place the sheet of cardboard from inside the carton onto your work surface to prevent scratching the sweeper.

STEP 2 - IDENTIFY BRUSH ASSEMBLIES

•Each brush assembly has one brush retainer marked with either red or black ink.Lay out the brush assemblies as shown so that the brush retainers marked with ink are in the middle with the black one on your right and the red one on your left. See figure 1.

BRUSH RETAINER

MARKED BLACK

BRUSH RETAINER

MARKED RED

OVERLAP BRISTLES

FIGURE 1
STEP 3 - ATTACH R.H. BRUSH ASSEMBLY

IMPORTANT: The overlap bristles at the bottom of each brush help support the back side of the brush for better sweeper performance. Be sure the sweeper is turned as shown in figure 2 to correctly assemble the brushes.

•Attach the brush assembly with the black brush retainer to the right end of the brush shaft using two hex bolts

(D) and nylock nuts (H).The brush retainer marked with black ink must be placed to the middle of the sweeper. See figure 2.

NYLOCK NUT (H)

WELDED BRACE

HEX BOLT (D)

BRUSH

RETAINER

MARKED

BLACK

OVERLAP

BRISTLES

FIGURE 2

5