•Attach the brush assembly with the red brush retainer to the left end of the brush shaft using two hex bolts (D) and nylock nuts (H).The brush retainer marked with red ink must be placed to the middle of the sweeper. See figure 3.
•Turn a wheel to rotate the brushes. (The wheels drive the brushes in one direction only.) The overlap bristles should be on the back side of the brush as it rotates.
HEX BOLT (D)
BRUSH RETAINER
MARKED RED
NYLOCK NUT (H)
FIGURE 3
•Hold the right hitch tube against the right side of the sweeper so that the "76R" on the tube faces toward the sweeper. Attach the hitch tube using one hex bolt
(C) and nylock nut (I). Do not tighten yet. See figure 5.
HEX BOLT (C)
NYLOCK NUT (I)
HOUSING
MARKED “R”
TUBE MARKED
“76R”
HITCH TUBE (R.H.)
FIGURE 5
•The hitch tubes are stamped with a "77L" for the left tube and a "76R" for the right tube. The sweeper housing is marked with an "L" on the left with side and an "R" on the right side. See figures 4 and 5.
•Hold the left hitch tube against the left side of the sweeper so that the "77L" on the tube faces away from the sweeper. Attach the hitch tube using two hex bolts (C) and nylock nuts (I). Do not tighten yet. See figure 4.
NYLOCK NUT (I) | HEX BOLT (C) |
|
HOUSING
MARKED “L”
TUBE
MARKED
“77L”
HITCH TUBE (L.H.)
FIGURE 4
•Attach the height adjustment strap to the hitch tube using a hex bolt (B), the spacer bushing (M), a flat washer (K) and a nylock nut (I). See figure 6. Do not tighten yet.
HEIGHT ADJ. STRAP
SPACER | NYLOCK NUT (I) |
| |
BUSHING (M) |
|
FLAT WASHER (K) |
|
HEX BOLT (B) |
|
FIGURE 6
6