ASSEMBLY

TOOLS REQUIRED FOR ASSEMBLY

(2)7/16" Wrenches

Remove all parts and hardware packages from the carton. Lay out all parts and hardware and identify using the illustrations on page 3.

Insert each side of the axle of the impeller assembly into the frame tube. See figure 1.

Insert the two hex flange bearings (I) into the frame tube. See figure 1.

I

Slide a spacer (J) over the right side of the axle. See figure 3.

Attach the drive wheel (9) to the right (indented) side of the axle. Secure the wheel in place with a hub cap

(K). See figure 3.

J

K

9

I

FIGURE 1

Attach the hopper to the frame tube using two 1/4" x

1-1/2" hex bolts (A), 1/4" washers (G), and 1/4" nylock nuts (D) as shown in figure 2. Tighten.

Insert an 1/8" hair cotter pin (E) into the hole at the top of the impeller. See figure 2.

A E A

H H

D

D

FIGURE 2

FIGURE 3

Slide a spacer (J) over the left side of the axle. See figure 4.

Attach the wheel (10) to the left side of the axle. Secure the wheel in place with a hub cap (K). See figure 4.

J

10N K

FIGURE 4

4