•Place two 5/8" flat washers separated by a long spacer tube onto the shaft. See figure 20.

LONG SPACER TUBE

5/8" FLAT WASHER

FIGURE 20

•Place a spike disk and a short spacer tube onto the shaft. Fit the short spacer tube onto the ends of the flanged bearings in the spike disk and in the end plate. Push the shaft on through the flanged bearing in the end plate. See figure 21.

SPIKE DISK

SHORT SPACER TUBE

FIGURE 21

•Place a 5/8" flat washer onto the end of the spike disk shaft and secure the shaft with a 1/8" x 1-1/2" cotter pin. See figure 22.

•Fasten the two drive disks to the shaft using two 1/8" x 1-1/2" cotter pins. See figure 22.

1/8" x 1-1/2"COTTER PIN

DRIVE DISKS

5/8" FLAT WASHER

FIGURE 22

•Assemble the chain onto the two sprockets on the left side of the hopper. Fasten the ends of the chain together using the connecting link. See figure 23.

•Place the chain cover over the chain and fasten it to the hopper end plate using two self tapping screws.

See figure 23.

SELF

TAPPING

SCREW

CHAIN

CONNECTING

LINK

FIGURE 23

11