Craftsman 486.24331 FIGURE, FIGURE, FIGURE, FIGURE, FIGURE, IMPORTANT:, Place the 1/4" thick spacer onto the spike disk shaft

•Push two flange bearings into each of the drive disk assemblies. See figure 11.

DRIVE DISK

ASSEMBLY

FLANGED

BEARING

FLANGED

BEARING

FIGURE 11

•Push a flange bearing into each of the seven drive disks, from the side shown in figure 12.

SPIKE DISK	FLANGED
	BEARING

FIGURE 12

•Press flanged bearings into both of the end plates. See figure 13.

•Place the 1/4" thick spacer onto the spike disk shaft and then insert the shaft through the flanged bearing in the left hand end plate. See figure 13.

FLANGED	FLANGED
BEARING	BEARING

1/4" THICK SPACER

SPIKE DISK SHAFT

FIGURE 13

•Place a short spacer tube, a drive disk, a 5/8" flat washer, another drive disk and a second 5/8" flat washer onto the shaft. Fit the short spacer tube onto the flanged bearing in the end plate. See figure 14.

DRIVE DISKS

SHORT SPACER

TUBE

5/8" FLAT WASHER

FIGURE 14

IMPORTANT: When assembling the spike disks, be sure they face in the direction shown in the instructions.

•Place two spike disks, separated by a long spacer tube, onto the shaft. Fit the long spacer tube onto the ends of the flanged bearings in the disks. See figure

15.

LONG SPACER TUBE

SPIKE DISK

FIGURE 15

9