HOW TO START YOUR VAC SYSTEM
without all covers being properly attached to the
_,ARNING: Never start or run the engine blower housing and cart.
•Check oil and gas in Vac engine.
•Attach spark plug wire to spark plug.
•Move choke lever on engine to CHOKE position. (A warm engine may not require choking.)
•Move throttle control lever on engine to FAST position.
•Grasp starter handle and pull rope out slowly until engine reaches start of compression cycle (rope wilt pull slightly harder at this point). Let the rope rewind slowly.
•Pull rope with a rapid, continuous, full arm stroke. Keep a firm grip on starter handle. Let rope rewind
slowly. Do not let starter handle snap back against starter.
•Repeat instructions in two preceding paragraphs until engine fires. When engine starts, move choke control gradually to RUN position.
HOW TO USE YOUR VAC SYSTEM
CAUTION: Vehicle braking and stability may be affected with the addition of an acces- sory or an attachment. Be aware of changing conditions on slopes.
•Inspect the Vac to make sure the cover, rear door, boot, elbow, hose adapter (nozzle), hose and deck adapter are properly attached.
•Check tires for proper inflation (12 - 14 Ibs).
•Check for oil and gas in Vac engine.
•Begin operation at low speed, adjusting forward speed to match grass height and/or moisture condition to prevent clogging.
•Do not attempt to vacuum up any material other than vegetation found in a normal yard, such as light branches, leaves, twigs, etc.
WARNING: Should your Vac System become clogged, shut off tractor and Vac engines. Before attempting to unclog, remove wire from spark plug to prevent accidental starting.
TO EMPTY THE CART
•Shut off the tractor engine and set the brake.
•Shut off the Vac engine.
•Loosen the draw string and pull the boot back from the elbow.
•Unzip the rear flap, flip it up and secure it with the velcro strips on top of the cover.
that no one is near the cart before releasing the
,_CAUTION: To avoid possible injury, be sure latch lock lever.
•Remove the tailgate.
•Release the latch lock lever on the tongue and tip the cart back.
•Using a rake or suitable tool, pull grass clippings and/ or leaves out of the cart.
•After the cart is emptied, tip it forward and secure it to the tongue with the latch lock lever. Install the tailgate, place the bottom of the rear flap inside the tailgate and zip the rear flap shut.
TO USE THE CART WITHOUT THE VAC SYSTEM
•Unzip the rear flap and unfasten the velcro fasteners.
•Remove and store the soft top cover.
•Remove the tube frame in one piece and store.
areCAUTION:hot! The muffler and adjacent areas
•Remove and store the four bolts and nuts which fasten the engine base to the tongue.
•Slide the engine off the tongue and roll to a safe storage area.
19
