Craftsman 486.24515 Lock, Hexnut, Installthepolyhardtopoverthefrontandsidepanels, Washor

Installthepolyhardtopoverthefrontandsidepanels.

Fastenusingfourteen1/4"x3/4"hexbolts,1/4"flat

washers,1/4"lockwashersand1/4"hexnuts.See

figure17.

Assemble the five clamps onto the cart flanges, placing one in f_ontcenter and two on each side,

positioned approximately 12" from each end. Use a 3/8" x 1-1/2" hex bolt to secure each clamp from the bottom. See figure 17.

POLY HARD TOP 1/4" HEXNUT 1/4"LOCK

WASHER

CLAMP

CLAMP 3/8" x 1-1/2"

FRONT

FIGURE 17

Assemble a door latch at each end of the cross brace using a 5/16" x 3/4" hex bolt, a nylon washer and a 5/16" hex lock nut. Place nylon washer between door latch and cross brace. Tighten so that latch is snug but will still rotate. See figure 18.

Assemble door support brackets underneath the rear of the cart bed by removing the hex nuts from the bolts shown in figure 18. Fasten the brackets to the' cart using the same hex nuts which were removed.

5/16" HEX	NYLON	CROSS
LOCKNUT	WASHER	BRACE

• 5/16" x 3/4 •

HE)( BOLT

BOLT

DOOR

BRACKET

; -HEXNUT

FIGURE 18

Assemble one short tie strap to each side of rear door using one 1/4" x 1-1/4" hex bolt, two 1/4" fiat washers, one 1/4" lock washer and one 1/4" hex nut. Assemble an "S" hook through the loose end of each strap. See figure 19.

•Assemble a 1/4" x 1" hex bolt with a 1/4" hex nut to outside of hole on each side of cart bed and secure from inside with a 1/4" lock washer and a 1/4" hex nut. See inset in figure 19.

•Assemble door to rear of cart by resting bottom of door on door support brackets and rotaUng top of door forward to meet cross brace. Latch top of door on each side. See figure 19.

•Hook both the fie straps onto the 1/4" x 1• hex bolts which were just assembled. See figure 19.

._CROSS BRACE_. DOOR

			,	_ ,,	_f t_"	_,
			"_,;1/4"'FLJ_T_-_'_?			HEX BOLT
						LOCK
STRAP			'	--'_ ""		1/4
.....				T"'_"-'_I/4		• FLAT
1/4	; ,, WASHOR
		xl
			HEX NUT		""_u-_1/4"	LOCK WASHER
FIGURE		19

11