Assemble the front panel over the end of the cart using six 1/4" x 1/2" hex bolts and 1/4" hex nuts
(SEMS) as shown in figure 4. Leave two holes open in the bottom of the panel as shown in figure 4. With the cart body halves pulledtogether, tighten the four bolts in the bottom of the front panel, then tighten the bolt in each side.
At this time tighten the three bolts on the bottom of the cart which were assembled in figure 1.
LEAVE HOLES OPEN FOR | 1/4" x 1/2" | |
LATCH STAND BRACKET | ||
HEX BOLTS | ||
|
1/4" HE]( NUT (SEMS)
1/4" HEX NUT (SEMS)
FIGURE 4
Assemble the wheel supportto the bottom of the cart using eight 5/16" x 3/4" slottedhead screws and
5/16" hex nuts (SEMS) as shown in figure 5. Heads of screws go to the inside of cart. Tighten.
SLO'n'EDSCREW 5/16" x 3/4"
WHEEL
SUPPORT
\
5/16" HEX- NUT (SEMS) _
Assemble the latch stand bracket to the cart using four 1/4" x 1/2" hex bolts and 1/4" hex nuts (SEMS). TIGHTEN. See figure 6.
LATCH STAND BRACKET
1/4" x 1/2"
HEX BOLT
\
1/4" HEX NUT (SEMS)
FIGURE6
To prevent accidental tipping during the following assembly procedures, lower the cart to rest upside down on the top flanges, so that the wheel support is facing up as shown in figure 7.
FIGURE 7
FIGURE 5
