Craftsman 486.24515 owner manual 33/8

•Assemble the front tongue over the top of the rear tongue using three 3/8" x 3" hex bolts, 3/8" lock washers and 3/8" hex lock nuts. See figure 8.

(3)3/8" x 3"

TONGUE _,/HEX BOLTS

(REAR) _ TONGUE

(3)

WASHERS_'-_-.-.(3) 3/8" HEX

LOCK NUTS

FIGURE 8

•Assemble the hitch bracket to the front tongue using "' two 3/8" x 1-1/4" hex bolts, 3/8" lock washers and 3/8" hex nuts. Tighten. See figure 9.

3/8" x 1-1/4"		_	HITCH BRACKET	..
HEX BOLT		"'"_1	/
.
3/8	LOCK	_"_I_	TONGUE
WAS H ER _..._........_			/
LOCK	NUT---_

FIGURE 9

•Assemble the latch lock assembly to the tongue using two 1/4" x 2-3/4" hex bolts, two 1/4" lock washers and two 1/4" hex nuts. Fasten to the two front holes in the forward grouping of four holes as shown in figure 10.

•Assemble the angle stop to the tongue using two 1/4" x 2-3/4" hex bolts, two 1/4" lock washers and two 1/4" hex nuts. Fasten to the two front holes in the rear

grouping of four holes as shown in figure 10.

	HE)( BOLT
ANGLE	LATCH LOCK
	ASS'Y.
	TONGUE

1/4" LOCK	WASHER
WASHER	1/4" HEX
	NUT
FIGURE 10

Position the tongue on the bottom of the cart as shown in figure 11. Assemble the axle through the wheel support and the tongue. Fasten the axle to the wheel support using two 1/4" x 1-3/4" hex bolts and 1/4" hex nuts (SEMS). Tighten.

IMPORTANT: Make sure the tongue is securely locked to the latch stand bracket by the latch lock assembly.

1/4" x 1-3/4"

HEX BOLT

AXLE

"_ (DRAW BAR)

TONGUE

114" HEX

NUT (SEMS)

FIGURE 11

•Assemble a spacer tube onto each end of the axle as shown in figure 12.

•Assemble a flat washer, a wheel (valve stem facing out), and another flat washer onto the axle as

shown in figure 12. Secure the wheel with a cotter pin, spreading the ends so that a hub cap can fit

over the pin. Assemble the hub cap by pressing it onto the flat washer. Repeat on other end of axle.

SPACER TUBE

WHEEL

FLAT

WASHER

\

FLAT

tWASHER

HUB CAP CoI-rER PIN

FIGURE 12