CAUTION!Muffleris hot!Allowengineto cool downbeforeproceedingwith bumper installation.
STEP 1 : (SEE FIGURE 2)
*Remove tractor hood. (Refer to tractor manual.)
*Remove the browning shield as shown below.
STEP 4: (SEE FIGURE 5)
*Spread ends of bumper enough to fit slots onto bolts in rear mounting holes in tractor frame.
*The bumper has three mounting holes. The rear hole provides the most clearance while the forward holes provide a neater appearance. Use a hole that provides enough clearance for hood to stay in raised position when opened. Insert a hex bolt (C) through tractor frame and into desired mounting hole on each side of bumper and secure with a hex nut (D).
iMPORTANT: Before fully tightening nuts, be sure tractor hood will stay in raised position when opened.
REMOVE
FRONT SCREWS
REMOVE
BROWNING SHIELD
FIGURE 2
STEP 2: (SEE FIGURE 3)
*Insert a hex bolt (C) into the second mounting hole from the front of the tractor frame and fully tighten a hex nut
(D)onto the bolt. Repeat on other side of tractor.
HEX BOLT (C)
HEX BOLT (C)
(D)
/
\
HEX NUT (D)
FIGURE 3
STEP 3: (SEE FIGURE 4)
*Place plug (E) on a work bench or solid table and push end of bumper down onto plug. Repeat for second plug.
BUMPER |
|
PUSH DOWN |
|
WITH EVEN |
|
PRESSURE |
|
WORK BENCH | SHORT STEP |
OR SOLID TABLE | PLUG (E) |
|
FIGURE 4
STEP 5: (SEE FIGURE 6)
*Replace the browning shield using the front screws you removed in Step 1.
/
REPLACE
FRONT SCREWS
REPLACE
BROWNING SHIELD
FIGURE 6
3
