
ASSEMBLY OF THE SNOW THROWER
STEP 15: (SEE FIGURE 15)
•Place the lift handle into the lift bracket on the right side of the snow thrower. Fasten the handle to the bracket
using two 5/16" x
LiFT HANDLE
STEP 17: (SEE FIGURE 17)
Tilt the snow thrower back down to the ground. Remove the nylon tie which fastens the auger drive belt to the discharge housing, leaving the belt assembled around the pulleys.
Remove the nylon tie which fastens the chute crank rod to the crank rod support tube.
Assemble the crank rod support tube to the bracket on the left side of the discharge housing using two 5/16" x
DISCHARGE\ \
HOUSING\\
\
FIGURE 15 | RIGHT SiDE ViEW |
NOTE: Be sure the lift release cable's plastic covering stays inserted into the trigger assembly for the next step.
5/16"NYLOCK NUT
CRANK ROD SUPPORTTUBE
STEP 16 (SEE FIGURE 16)
Push the lift handle down into the locked position. Insert the end of the cable wire into the hole in the lift rod. Place the threaded fitting into the slot in the lift bracket, with one hex nut above and one hex nut and the lock washer below the slot. Tighten the nuts, adjusting them to eliminate slack in the cable wire. Refer also to the Service and Adjustments section on page 18 in this manual.
HINT: For easier assembly of the lift release cable, tilt the ,now thrower forward onto the spiral auger.
LIFT RELEASE
CABLE
HEX NUT
TRIGGER
ASSEMBLY
LOCK
WASHER
HEX NUT
CABLE
WIRE
LIFT
ROD
FIGURE 16 | RIGHT SiDE ViEW |
FIGURE 17 | LEFT SIDE ViEW |
STEP 18: (SEE FIGURE 18)
Attach the chute tilt control assembly to the top side of the crank support tube using two 5/16" x
CHUTE | CRANK | ROD | ||
CRANK | SUPPORTTUBE |
| ||
TiLT CONTROL HANDLE | _(_ | |||
5/16" | x |
| TiLT | |
| CONTROL | |||
CARRIAGE | BOLT | |||
ASSEMBLY | ||||
|
|
| ||
BOWED | WASHER |
|
| 5/16" NYLOCK NUT |
FIGURE 18 | LEFT SiDE ViEW |
12