LOCATE TRACTOR'S MODEL LABEL
Look under your tractor seat to locate the model number label shown below. This manual is for tractors with model
numbers that start with 247 as shown below.
CAUTION: Before starting to assemble the snow thrower, remove the spark plug wire(s), set the parking brake and remove the key from the tractor ignition.
247 MODEL TRACTORS
CRRFTSMgH°
CONFORMS TO ANSi B71,1=2003 SAFETY STANDARDS
TRACTOR PREPARATION
Before performing these instructions, refer to the Service and Adjustments section of your tractor owner's manual for specific safety instructions.
III1 1111111 | 111111111111 • |
|
|
| |
IIIIIlilln,,,........,,, | Allow engine, muffler and exhaust deflector | to cool | |||
SERIAL 000000A000000 |
| before beginning. |
| ||
| Remove | any front or rear attachment which | is | ||
FOR PARTS AND SERVICE CAll |
| ||||
SEARS, ROEBUCK AND CO, Iloffman Es[ates, IL 60179 | mounted | to your tractor. |
| ||
| 193653 _,_ |
| |||
|
| Remove the mower deck. Refer to your tractor owner's | |||
IMPORTANT: If your model number | starts with 917, use | manual for removal instructions. Mark all loose parts | |||
and save | for reassembly. |
| |||
the owner's manual and the parts that are contained in |
| ||||
Remove the tractor hood. Refer to your tractor owner's | |||||
|
| ||||
the other parts bag. | manual for removal instructions. |
|
TOOLS REQUIRED FOR ASSEMBLY
(2)7/16" Wrenches
(2)1/2" Wrenches
(2)9/16" Wrenches
(2)3/4" Wrenches
(1)Knife
IMPORTANT: Right hand (R.H.) and left hand (L.H.) side of the tractor are determined from the operators position while seated on the tractor.
ADDITIONAL ITEMS REQUIRED
General Purpose Grease
REMOVAL OF PARTS FROM CARTON
Remove all loose parts, parts bags and hardware bags from the carton. Lay out and identify parts and hardware using the illustrations on pages 4, 5 and 6. The parts bag labeled for 917 model tractors will not be needed.
IMPORTANT: Not all items supplied in the hardware bag will be needed for your particular tractor. Unneeded items may be discarded after you have completed assembly and checked operation of unit. DO NOT DISCARD the two spare shear bolts (K) and 5/16" nylock nuts (HH). Refer to the Service and Adjustments section on page 18.
