KNOW YOU R SNOW TH ROWER
Read this owner's manual and safety rules before operating your snow thrower.
Compare the illustration below with your snow thrower to familiarize yourself with the various controls and their locations.
LIFT RELEASE TRIGGER
LIFT HANDLE | CHUTETI_ | HANDLE |
J |
| |
| // |
|
• | /.J |
|
UPPER CHUTE | CRANK | ROD |
|
| |
LOWER CHUTE |
|
|
S
SCRAPER PLATE
SPIRAL AUGERS, R.H.& L.H.
CHUTE TiLT HANDLE Pivots the Upper Chute up or down to control the angle and distance of discharge. CRANK ROD Rotates the Lower and Upper Chutes to
control the direction of discharge.
LIFT HANDLE Used to lift or lower the snow thrower to transport or operating position.
LIFT RELEASE TRIGGER Releases the lock which holds the snow thrower in the transport position
SKID SHOE
UPPER AND LOWER DISCHARGE CHUTE Controls direction and height of snow discharge.
SCRAPER PLATE Replaceable plate that absorbs wear and impact from contact with ground.
SKID SHOE Controls amount of clearance between the scraper plate and the ground.
SPIRAL AUGER, R.H. & LH. Feed snow to the impeller fan at the center of the housing.
BEFORE STARTING
•Use the end of assembly checklist to verify that all instructions have been properly completed.
Make sure the skid shoes are adjusted to maintain adequate ground clearance between the snow thrower and the type of surface to be cleared. (Refer to the Service and Adjustments section.)
Make sure the tractor engine has the correct oil for winter operation (SAE
HOW TO STARTYOUR SNOW THROWER
The tractor should be sitting with the engine running at full throttle. Move the attachment clutch to the
engaged position, starting the snow thrower before
the tractor clutch is engaged.
HOW TO STOP YOUR SNOW THROWER
To stop the snow thrower, disengage the tractor's attachment clutch lever for manual clutches or the
clutch switch for electric clutches. Refer to your tractor owner's manual.
HOW TO USE YOUR SNOW THROWER
CAUTION: Never direct discharge towards bystanders or windows. Do not allow anyone in front of unit.
CONTROLLING SNOW DISCHARGE
To control the direction snow is thrown, the discharge chute has 180 degrees of rotation. Turn the crank rod clockwise to rotate the chute to the right. Turn the crank rod counterclockwise to rotate the chute to the left.
To control the distance snow is thrown, the upper section of the discharge chute pivots up and down. Push forward on the chute tilt handle to pivot the chute down, decreasing the distance snow is thrown. Pull back on the handle to pivot the chute up, increasing the distance snow is thrown.
16
