11
THIS SECTION IS FOR TRACTORS WITH AN ELECTRIC ATTACHMENT CLUTCH
STEP 14: (SEE FIGURE 14)
• Attachthetwosuspensionarmstotherearofthe
clutch/idler assembly using two 5/16" x 3/4" hex bolts
(E) and 5/16" nylock nuts (CC) for each arm. Place the
arms on the outside of the frame with the notches to
the rear.
• Insertatensioningchainthroughtheholeshownand
attach the end link to the spring on the lower idler arm.
FIGURE 14 FIGURE 16 VIEW OF BOTTOM
STEP 16: (SEE FIGURE 16)
• Hookoneendofthespringsuppliedinthepartsbag
through the end link of the tensioning chain.
• Withtheclutch/idlerassemblyturnedupsidedown,
hook the other end of the spring onto the end of the
bolt and nut which secure the idler pulley to the upper
idler arm. Assemble a 3/8" hex lock nut (DD) onto the
boltandnut,leavingenoughgapbetweenthenutsfor
thespringtopivotfreely.
• Attacha3/32"hairpincotter(LL)tothechain,placing
itinthefthlinkfromthespring.
CHAIN
(L.H. SIDE)
3/32" HAIR
COTTER PIN (LL)
5TH LINK
LEFT
SIDE
3/8" HEX
LOCK NUT (DD)
SPRING
RIGHT
SIDE
ATTACH
SPRING
HERE
STEP 15: (SEE FIGURE 15)
• Turntheclutch/idlerassemblyupsidedownandplace
the extra tensioning chain (PP) through the left front
hole.
FIGURE 15
TENSIONING CHAIN (PP)
LEFT FRONT HOLE
STEP 17: (SEE TABLE 1)
• Twodifferentlengthdrivebeltsareincludedwith
your snow thrower. Use the table below to select
thecorrectdrivebeltforyourtypetractor.Thepart
number is printed on the outside of the belt .
• Setasidethebeltthatisnotforyourtractortoavoid
accidentally using it.
SELECT THE CORRECT DRIVE BELT(Electric clutch tractors with a single front deck suspension bracket)
55" BELT (PART #46989)
TRACTOR TYPE DECK SIZE CLUTCH TYPE
(LT) Lawn Tractor 38", 42" Electric
56" BELT (PART #48138)
TRACTOR TYPE DECK SIZE CLUTCH TYPE
(LT) Lawn Tractor 48" Electric
(GT) Garden Tractor 48", 54" Electric
TABLE 1
5/16" NYLOCK
NUT (CC)
5/16" x 3/4"
HEX BOLT (E) TENSIONING CHAIN (PP)