Assemble a shoulder bolt, a 3/8" lock washer and a 3/8" hex lock nut to the bottom hole in each side plate. See figure 3.
Proceed to page 8.
3_" HEX LOCK NUT
Attach the R.H. Side Plate (marked "R") to the right side of the tractor frame as shown in figure 5. For the front hole use a 3/8" x 1" hex bolt, a 3/8" lock washer, a 1/2" flat washer and a 3/8" hex lock nut. Use the flat washer as a shim between the frame and the side plate. For the rear hole use a 3/8" x 1" hex bolt, and a 3/8" lock washer. Repeat for the L.H. side.
NOTE: Depending on the tractor model, the bolt may insert freely into the front hole or it may screw into the hole. If the hole is not threaded, the bolt will form threads as it is screwed in.
_8"LOCK
WASHER
R. H. SIDE PLATE
3/8" SHOULDER BOLT
FIGURE 3 | RIGHT SIDE VIEW |
TRACTORS WITH AXLE MOUNTED FRONT SUSPENSION BRACKETS
•Remove the bolt from the hole on each side of the tractor frame as shown in figure 4.
REMOVE BOLT FROM
THIS HOLE
FRONT
SUSPENSION
BRACKET
FIGURE 4 | RIGHT SIDE VIEW |
3_"LOCKI_"FLAT
WASHERWASHER
3/8"HEX
LOCK NUT
3/8" x 1"
HEX BOLT
R.H. SIDE PLATE
FIGURE 5 | RIGHT SIDE VIEW |
•Assemble a shoulder bolt, a 3/8" lock washer and a 3/8" hex lock nut to the bottom hole in each side plate. See figure 6.
3/8"HEXLOCKNUT
_8"LOCK
WASHER
R.H. SlDE PLATE
3/8" SHOULDER BOLT
FIGURE 6 | RIGHT SIDE VIEW |
7
