INSTALLING THE ATTACHMENT PIN
Lift the front of the snow blower to align the holes in the mounting plates and the side plates. From the left side of the tractor install the attachment pin through the holes, securing it with the 1/8" hairpin cotter. Refer back to figure 29 on page 15.
SETrlNG THE AUGER BELT TENSION
Pull the tensioning chain until the end of the spring is pulled through the hole in the side of the Clutch/ Idler assembly. Install the 1/8" hairpin cotter through the end of the spring, securing it on the outside of the Clutch/Idler assembly. See figure 32.
IMPORTANT: For correct belt tension, the 1/8" hairpin cotter must attach to the end of the spring, not to the chain.
Hold this drawing above you while viewing the Clutch/idler Assembly from underneath the tractor. Right and left in the drawing will be the reverse of the viewer's right and left.
LEFT SIDE
OF
TRACTOR
FLAT
PULLEY
1/8"
HAIRPIN
END OF
SPRING
FIGURE 32VIEWED FROM UNDERNEATH
ATTACHING WEIGHT TRAY TO TRACTOR
Loosen the top hex bolt on each side of the tractor frame at the rear. Assemble the slotted end of the side braces down onto the loosened bolts. Do not tighten yet. See figure 33.
NOTE: If there is interference with the hex bolt when using tire chains with extra wide tires, assemble the side braces to the tractor frame using the alternate instructions with figure 35 on page 17.
Place the weight tray on top of the tractor hitch and fasten the side braces to it using two 5/16" x 1" carriage bolts, 5/16" lock washers and 5/16" hex nuts. Do not tighten yet. See figure 33.
•Fasten the weight tray to the tractor hitch using a 1/2" x
Fasten the cross brace to the side braces using two 5/16" x 1" carriage bolts, 5/16" lock washers
and 5/16" hex nuts. See figure 33. Tighten all loose bolts at this time.
ORIGINAL
HEX BOLT or
CROSSSLOTTED
_BRACE ,,,°=. 5 1 " __TRUSSBOLTHEAD
/ | CARRIAGE |
1/2" Lg_,K"_/ | BOLT |
WAS_ER | (- |
/H /,'/;.LOCK':
WAS.ER
gk"RlAG f S'DEBRAO
BOLT
WEIGHT TRAY
FIGURE 33
16
