•Remove the mower stop bracket and its two bolts and nuts from the R.H. side of the tractor frame as
shown in figure 3.
•If the tractor has a muffler guard at the front of the R.H. foot rest, remove the bottom bolt and nut, and the washer which is located between the guard and the tractor frame. See figure 3.
•Remove the two bolts from the bottom of both the R.H. and L.H. foot rests. See figure 3.
MUFFLER GUARD
_(ONLY MODELS WITH
SIDE MUFFLER)
Assemble the L.H. hanger bracket to the left side of
the tractor frame using two 3/8" x 1" hex bolts, two 3/8" lock washers and two 3/8" hex lock nuts as
shown in figure 5.
\
\
LH. HANGER 3/8" LOCK
BRACKETWASHER
3/8" x 1"
HEX BOLT
MOWER STOP i
BRACKET
//
FIGURE 3 | RIGHT SIDE VIEW |
Assemble the R.H. hanger bracket to the bottom
hole where the mower stop bracket was removed and to the bottom hole under the front of the foot
rest. Fasten with two 3/8" x 1" hex bolts, 3/8" lock washers and 3/8" hex lock nuts. (On tractors with muffler guards, slide the hanger bracket between the guard and the tractor frame.) See figure 4.
MUFFLER GUARD
(ONLY MODELS WITH SIDE MUFFLER)
R.H. HANGER
BRACKET
| 3/8" x 1" |
| HEX BOLT |
HEX | 3/8" LOCK |
LOCK NUT | WASHER |
FIGURE 4 | RIGHT SIDE VIEW |
FIGURE 5 | LEFT SIDE VIEW |
•Assemble the L.H. frame bracket (with bend) to the L.H. foot rest and sway bar bracket as shown in
figure 6. Use two 3/8" x 1" hex bolts and two 3/8" lock washers.
•Assemble a shoulder bolt to the outside of the L.H. frame bracket, securing it with a 3/8" lock washer and a 3/8" hex lock nut. See figure 6.
•Assemble the R.H. frame bracket to the R.H. footrest using the same procedures as in the two
previous paragraphs.
NOTE: The R.H. frame bracket has no bend. There is
no sway bar bracket on the right side of the tractor.
3/8" LOCK |
| SHOULDER |
WASHER | 3/8" x 1" | BOLT |
L.H. FRAME | HEX BOLT |
|
|
| |
BRACKET |
|
|
3/8" HEX LOCK NUT
/ | 3/8" LOCK J | / |
\WASHER _SWAY BAR
\\ \ BRACKET
FIGURE 6 | RIGHT SIDE VIEW |
7