MOUNTING SNOW THROWER TO TRACTOR
NOTE: The help of another person may be required to mount the snow thrower to the front of the tractor.
•Place the tractor and snow thrower on a flat, level surface.
•Remove the plastic tie from the auger belt and extend the belt out behind the snow thrower, making sure the belt remains assembled around the top of the large auger drive pulley and passing underneath the two side idler pulleys.
•Align the tractor behind the snow thrower.
•Remove the attachment pin from the snow thrower.
•Squeeze the release trigger on the lift handle and raise the handle out of the locked position. (If the handle will not release out of the locked position, refer to the Service and Adjustments section of this manual.)
•Grasp the round bar just behind the auger drive pulley and lift up to align the rear mounting notches on the snow thrower with the mounting pins on the tractor. Slide the pins into the notches.
HINT: If you are unable to fit the mounting pins into the notches, try placing 1" or 2" blocks of wood under the front skid shoes on the snow thrower.
•Assemble a 3/4" washer and a 1/8" hairpin clip to each mounting pin.
•Secure the snow thrower to the tractor using the attachment pin and 1/8" hairpin clip. Insert the attachment pin from the left side. See figure 15.
I | A'rrACHMENT PIN | I |
[] | 1/8" HAIRPIN CLIP '''''v |
|
1
814" FLAT
WASHER
FIGURE 15 | RIGHT SIDE VIEW |
ASSEMBLING THE BELTS
IMPORTANT: The tapered "V" section of the belts must be seated into the grooves of the
DRIVE BELT
•Remove the two outside 1/8" hairpin clips which are assembled to the L.H. and R.H. tension adjust- ing chains outside of the clutch idler assembly frame. (The clips will be reinstalled after both belts have been assembled.) Do not remove the 3/32" hairpin clips assembled to the chains on the inside of the assembly frame. See figure 16.
•Assemble the drive belt onto the tractor's engine pulley and then onto the upper rear pulley on the clutch/idler assembly. Keep the flat idler pulley on the outside of the belt. See figure 16.
Hold this diagram above you while viewing the
Clutch/Idler Assembly from underneath the tractor. Right and left in this diagram will be the reverse of the viewer's right and left.
RIGHT SIDE | ENGINE |
| LEFT SIDE |
OF TRACTOR | IPULLEY |
| OF TRACTOR |
IDLER |
|
|
|
PULLEY |
|
|
|
c_ |
|
|
|
FLAT | _ | _DRIV | |
1/8" | I' | '1 , C) |
|
|
|
|
HAIRPIN
CLIP
1/8"
HAIRPIN
CLIP
FIGURE 16VIEWED FROM UNDERNEATH
10