Oil Drain Plug
AIR CLEANER
Replace the filler once a year; more often under dusty or dirty conditions. DO NOT attempt to clean or oil the air filter.
To install a new air filter, do the following:
•Disconnect the spark plug wire from the spark plug.
•Turn the cover as shown below to the left
(counterclockwise) and remove.the cover and the air filter from the flange.
•Discard the air filter.
•Clean the cover and the flange thor- oughly.
•Insert the new air filter into the cover.
•Push the cover firmly against the flange and turn it to the right (clockwise) as far as it will go as shown in figure below. Be sure the retainers are locked around the flange.
•Reconnect the spark plug wire.
; Kn
cover to the left _"=_J _[ (counterclockwise)
•v to remove
Flange
CAUTION: Never run the engine without the air cleaner element installed. A defective air cleaner can result in loss of engine power and can cause excessive wear or damage to the engine components if dirt or dust is permitted to enter the engine through the carburetor. A damaged air cleaner, or one that is clogged with dust or dirt should be replaced immediately.
SPARK PLUG
Clean the spark plug and reset the gap periodically. Clean the area around the spark plug base before removal, to prevent dirt from entering the engine. Replace the Spark plug if the electrodes are pitted or burned or if the porcelain is cracked. Clean the spark plug by carefully scraping the electrodes (do not sand blast or use a wire brush). Be sure the spark plug is clean and free of foreign material. Check the elec- trodes gap with a wire feeler gauge and reset to .030 in. if necessary, ff a new spark plug is needed, refer to the PRODUCT SPECIRCATIONS on page 11 for the proper replacement spark plug.
Before reinstalling the spark plug, coat the threads lightly with graphite or light oil to insure easy removal. Tighten the spark plug firmly into the engine. If a torque wrench is available, torque the spark plug to 15 foot- pounds.
,Cover
Slot
Tab
to the right (clockwise) to install
