TROUBLE |
| CAUSE | CORRECTION | |
Difficult | starting | Defective spark plug | Replace defective plug | |
|
|
| Water or dirt in fuel system | Use carburetor bowl drain to |
|
|
|
| flush and refill with fresh fuel |
Engine | runs | er- | Blocked fuel line or low on fuel | Clean fuel line; check fuel sup- |
ratically |
|
|
| ply; add fresh gasoline (gaso- |
|
|
|
| line/oil mixture if |
Engine | stalls |
| Unit running on CHOKE | Move choke lever to OFF position |
Engine | runs | er- | Water or dirt in fuel system | Use carburetor bowl drain to |
ratiCally; |
|
|
| flush and refill with fresh fuel |
or |
|
|
|
|
Loss of power
Excessive vibration
Units fails to
_ropel itself
Unit fails to discharge snow
Loose parts; damaged impeller
_)dve belt loose or damaged
Incorrect adjustment of auger con- trol cable
Wom or damaged friction wheel Auger drive belt loose or dam- aged
Auger control cable not adjusted correctly
Shear bolt broken
Discharge chute clogged
Stop engine immediately and disconnect spark plug wire. Tighten all bolts and make all necessary repairs. If vibration continues, have the unit ser- viced by a Craftsman service repairman
Replace drive belt
Adjust traction drive cable
Repair friction wheel
Replace auger belt
Adjust auger control cable
Replace with shear pin located in tool box on belt cover.
Stop engine immediately and disconnect spark plug wire. Clean discharge chute and in- side of auger housing.
Foreign object lodged in auger | Stop engine | immediately and dis- |
| connect spark plug wire. Remove | |
| object from | auger. |
23
