6.Reinstallorificeandin-linefilterintonozzle

extensionDONOTovertightanorificewithallen.

wrench.

7.Reconnectnozzleextensionto spraygun.

8.Reconnectwatersupply,turnonwater,andstart

engine.

9.Testpressurewasherbyoperatingnozzlein high andlowpositions.

O-RingMaintenance

Purchase an O-Ring Repair Kit, item number 191922GS, at your local Sears sevica center. It is not included with the pressure washer. This kit includes replacement o-rings, rubber washer and water inlet filter. Refer to the instruction sheet provided in the kit to service your unit'so-rings.

Pump Maintenance

Changing Pump Oil

Change oil every 50 hours or once yearly, whichever occurs first.

NOTE: You must purchase a premeasured bottle of

pump oil, item number 190586GS at your local Sears sevice canter.

Change pump oil as follows:

1.Drain engine oil and fuel from pressure washer.

2.Use a 8mm allen wrench to remove black pump

oil cap between high pressure outlet and garden hose inlet.

J

3.Tilt pressure washer to drain oil into an approved container until it drips slowly from pump.

4.Tilt pressure washer in opposite direction and empty premeasured pump oil bottle into same opening (a small funnel may be helpful).

5.Install black pump oil cap and tighten firmly.

6.Set pressure washer in upright position. Add fuel and engine oil.

ENGINE MAINTENANCE

Checking Oil Level

Oil level should be checked prior to each use or at least every 8 hours of operation, Keep oil level maintained,

Changing Oil

Change engine oil after the first 5 hours and every 50 hours thereafter. If you are using your pressure

washer under extremely dirty or dusty conditions, or in extremely hot weather, change oil more often.

CAUTION

certain laboratory an!reals.

• Thoroughly wash exposed areas with soap and water.

DON'TPOLLUTE. CONSERVE RESOURCES. RETURN USED OIL TO

)COLLECTIONKEEPOUTOFCENTERSREACHOF. CHILDREN.

Change oil while engine is still warm from running, as follows:

1.Drain fuel tank by running pressure washer until fuel tank is empty.

2.Disconnect spark plug wire and keep it away from spark plug.

3.Clean area around oil fill, remove oil fill cap/dipstick. Wipe dipstick clean.

4.Tip your pressure washer to drain oil from oil fill into a suitable container making sure you tip your unit away from spark plug and air cleaner. When crankcase is empty, return pressure washer to upright position.

5.Wipe dipstick clean, insert it into oil fill hole and tighten securely, remove dipstick. Add recommended oil up to "Full" mark on dipstick. Pour slowly. Wipe dipstick clean each time oil level is checked. DO NOT overfill.

6.Install oil fill plug and dipstick, tighten securely.

7.Wipe up any remaining oil.

8.Reconnect spark plug wire to spark plug.

13

Page 13
Image 13
Craftsman 580.6722 owner manual Engine Maintenance, Pump Maintenance, Changing Oil