Yourpressure washer requires some assembly and is
ready for use only after it has been properly serviced with the recommended oil and fuel.
If you have any problems with the assembly of your pressure washer, please call the pressure washer helpline at
IMPORTANT: Any attempt to run the engine before it has been serviced with the recommended oil will result
in an engine failure.
2.Place nozzle extension, turbowand and spray gun into holder.
REMOVE PRESSURE WASHER FROM CARTON
Open carton and slice two corners opposite guide handle from top to bottom so the panel can be folded down flat.
Remove fillers, accessories and parts bag shipped with your pressure washer.
Remove the pressure washer out the open end of the carton.
Check carton for additional loose parts.
CARTON CONTENTS
Check all contents, If any parts are missing or damaged, cell the pressure washer helpline at
The main unit
High pressure hose
Spray gun
Nozzle extension with adjustable nozzle
Turbo wand
Accessory holder
Engine oil
Parts bag (which includes items listed below) Owner's manual
Registration card
Become familiar with each piece before assembling the pressure washer. Compare contents against the view on page 5. If any parts are missing or damaged, call the pressure washer helpline at
ASSEMBLING YOUR PRESSURE WASHER
Your Craftsman pressure washer was mostly
assembled at the factory, However, you will need to perform these tasks before you can operate your pressure washer:
1.Add oil to engine crankcase.
2.Add fuel to fuel tank.
3.Connect high pressure hose to spray gun and pump.
4.Connect water supply to pump.
Attach Accessory Holder
1, Place accessory holderonto top of handle,
Add Engine Oil
IMPORTANT: Any attempt to crank or start the engine before it has been properly serviced with the
recommended oil may result in an engine failure,
NOTE: When adding oil to the engine crankcase, use only high quality detergent oil rated with API service classification SF, SG, SH, SJ or higher rated SAE 30 weight, DO NOT use special additives,
1.Choose a viscosity according to the following table.
STARTING TE_ FERATURE RANGE AINTICI PATE E) BEFORE NEXT OIL CHANGE
*The use of
**If using SAE 30 oil in temperatures below 40=F
(_=C), it will result in hard starting and possible engine bore damage due to inadequate lubrication.
2.Place pressure washer on a level surface.
3.Clean area around oil fill.
4.Remove oil fill cap and dipstick.
5.Wipe dipstick clean, insert it into oil fill hole and tighten securely, remove dipsticK. Add recommended oil up to "Fall" mark on dipstick.
6
